Cashino LP-56 Manuel de l'utilisateur - Page 9

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Cashino LP-56. Cashino LP-56 13 pages. Thermal label printer

Imprimer la page

4.2 Printer status description

The printer has three indicator lights, namely the power indicator light, the error indicator light, and

the Bluetooth indicator light.

POWER indicator

(Green)

Keep bright

4.3 paper feeding

(1) Load the thermal label paper roll into the paper roll

Note: The paper roll should fall to the root of the paper roll; the paper runs in the direction shown in

the figure during printing. Pay attention to the direction of the paper roll when installing.

(2) Turn the cover opening knob to open the upper cover of the print head

(3) Peel off a few sheets of labels at the end of the thermal label paper, and the length of the backing

paper after peeling is about 200mm. Then, as shown in the figure below, pass the thermal label paper

around the pressing shaft and pass it into the paper passage from the opening of the paper passage.

The first label is pressed on the printing rubber roller.

Note: Make sure that the bottom edge of the paper reaches the support board, and the end of the

first label should not exceed the peeling knife in front of the printing rubber roller.

(4) Close the upper cover of the print head, and adjust the paper adjustment block up and down to a

suitable position according to the width of the thermal label paper. Generally, it is recommended to adjust

it to 0.5-1mm wider than the paper.

(5) Turn the backing paper of the thermal label paper around the peeling knife, the printing rubber

www.csntek.com

Xiamen Cashino Technology Co., Ltd.

STATUS indicator

(Red)

Flash 3 times

Flash 5 times

Flash 6 times

LP-56 Thermal Label Printer

buzzer

3 beeps

5 beeps

6 beeps

Printer status

Working properly

No paper

Printer head over heating

Platen not pressed down