Duncan Apollo Jazz Bass - neck Diagrammes de câblage - Page 2
Parcourez en ligne ou téléchargez le pdf Diagrammes de câblage pour {nom_de_la_catégorie} Duncan Apollo Jazz Bass - neck. Duncan Apollo Jazz Bass - neck 2 pages. Pickup
Imprimer la page
Wiring Diagrams for
Pickup Models:
Quarter Pound P-Bass
5427 hollister avenue, Santa Barbara, CA 93111
805.964.9610 • seymourduncan.com
Wiring for 5 String Quarter-Pound for P-Bass
Visit seymourduncan.com for additional wiring diagrams.
P-Bass and Fender are registered trademarks of FMIC, with which Seymour Duncan is not affiliated
®
- 5 strg
Seymour Duncan
Seymour Duncan
Cong ratu lati ons on your purchase of a fine, h and-bui l t,
Seymou r D uncan bass gui tar pi ckup! I nstal li ng thi s picku p
in you r bass isn' t rocket scie nce. And, i f you're al ready handy
w it h tools, i t 'l l be a snap for you,and fun too! But i f you have
no expe rie nce handli ng red-hot sol de ri ng i rons, you'd be
we ll advi se d to take your new pi ckup and your trusty
ba ss to a qu al i fied g ui tar te ch .
The basic steps for installation include:
1. Remove the strings from your bass.
2. Remove the control plate and flip it over.
3. De-solder the original pickup's wires from the controls and
make sure to remember where they were connected.
4. Remove the pickup from the pickup cavity.
5. If the foam in the cavity of your bass has degraded, then
replace it with the foam included with your pickups.
6. Put your SD bass pickup into the pickup cavity.
7. Tin the wires from the SD bass pickup, and then solder them
into place.
8. Replace the control plate.
9. Re-string your bass, and adjust the pickups so they are set
about 3/16" from the strings when they are pressed down at
the highest fret on the neck.
®
Tip (hot output)
Output Jack