Danfoss VLT FC 103 Manuel d'instructions d'installation - Page 9

Parcourez en ligne ou téléchargez le pdf Manuel d'instructions d'installation pour {nom_de_la_catégorie} Danfoss VLT FC 103. Danfoss VLT FC 103 10 pages. Igbt module replacement for d1h–d8h drives
Également pour Danfoss VLT FC 103 : Manuel d'utilisation (16 pages), Manuel d'installation (20 pages), Manuel d'instructions d'installation (6 pages), Manuel d'installation (18 pages), Manuel d'instructions d'installation (8 pages), Manuel d'installation (6 pages), Manuel d'utilisation (16 pages), Manuel d'installation (16 pages), Manuel d'installation (8 pages), Manuel d'instructions d'installation (6 pages), Manuel d'installation (6 pages)

Installation Instructions

1.5 Reassembly Guidelines

1.5.1 Installing Current Sensors and Busbars

Install the current sensors and busbars using the following steps.

Secure the current sensor brackets to the terminal mounting plate with 6 nuts (M4), 2 in each bracket.

Position the 3 current sensors with the arrow on each sensor facing away from the fan housing. See Illustration 1.8.

Secure the 6 screws (M4) that connect the current sensors to the brackets, 2 in the base of each sensor.

Secure the 3 retaining nuts (M10), 1 in the base of each output terminal busbar.

Place the terminal label back in its original position.

Current sensor bracket

Nut (M4)

Output terminal busbar

Current sensor bracket

Nut (M4)

Illustration 1.8 Current Sensors and Busbars

MI92Q102

500 A Current Sensor Kit for

E1/E2 Enclosure Sizes

VLT

FC 102, FC 103, FC 202, FC 302

Heat sink cable connector

Current sensor cables

Current sensor cable connector

Current sensor

Output terminal busbar retaining nut (M10)