Danfoss TP5000 RF Si Manuel d'instructions d'installation - Page 9
Parcourez en ligne ou téléchargez le pdf Manuel d'instructions d'installation pour {nom_de_la_catégorie} Danfoss TP5000 RF Si. Danfoss TP5000 RF Si 14 pages. 5/2 day programmable electronic room thermostat
Également pour Danfoss TP5000 RF Si : Manuel d'installation et d'utilisation (14 pages), Instructions pour l'utilisateur (2 pages)
Imprimer la page
- 1. Installation Instructions
- 2. Product Specification
- 3. Installation
- 4. Commissioning (RF Models Only)
- 5. Your Programmable Room Thermostat
- 6. Preset Programmes
- 7. User Instructions
- 8. Before You Start
- 9. Setting the Clock & Day
- 10. Running Your Programme
- 11. Before You Change the Preset Programmes
- 12. Changing the Preset Programmes
- 13. User Overrides
- 14. Frost Protection
- 15. Battery Replacement
Before you start
Open the fl ap on the front of the
programmer.
Press the + & – AND
simultaneously to reset the unit.
This will reinstate the preset programmes
and will set the time to 12:00 on Day 1 and
the temperature to 20°C.
Setting the Clock & Day
Note: clock is displayed in 24 hour mode.
CLOCK
Press PROG to begin programming.
Use + or - to adjust the TIME (press and
hold to change in 10 min increments).
DAY
Press PROG again.
Use + or - buttons until correct DAY is
shown (1 = Monday, 2 = Tuesday, etc).
!
Remember - you will have to reset
the time when the clocks change in
Spring and Autumn.
&
buttons
i2 00
GB
9