3W 28i Manuel de l'utilisateur - Page 16
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} 3W 28i. 3W 28i 18 pages.
Imprimer la page
intelligent Ignition System with microprozessor controlled auto timing
General
For optimum operation of combustion engines an ignition system with auto timing is necessary. For easy starting
up a spark is ideal in the upper dead point position of the pistion. With increasing rpm a pre-ignition timing up to 30
degree is needed.
This is achieved with our new system using a high precision rpm-check by two magnets built-in the hub of the engine.
The hallsensor transmits the signal to the microprocessor, programmed with our engine characteristic.
Technical specifications
Temperature range :
Voltage range:
Operation voltage
Open - circuit current
Current - consumption
Ignition Voltage
Rpm. max
Magnet red (north pole)
Magnet green (south pole)
Like all other electronic devices the ignition box gets warm under operating conditions. For that reason a simple
airflow has to be guaranteed. Therefore the 4 delivered rubbermounts have to be used for installation, insuring a
one millimeter gap underneath the box.
Cable information
blue wire
red / black with bigger dia, with socket
red / black with plug
yellow / white with socket
Info about red LED
a) Ignition battery switched on:
b) Propeller one turn (flip):
c)
Propeller not being turned (flipped), after
twenty seconds:
- the engine cannot be started by coinsidence if sombody forgot to switch off the ignition
- battery will be protected against incidental discharge
d) in case the LED will not get off when propeller is turned (fliped): hall sensor is not connected or other defect
IIS - IGNITION SYSTEM
o
o
- 40
C / + 65
C
ambient temperature
4,8 V - 7,5 V
five cells NICAD
one - cylinder
6,0 V
18 mA
20 mA
100 mA
950 mA
1100 mA
> 20 kV
12.000 rpm
upper dead point
o
55
before upper dead point
This safty function has two reasons:
more infos: www.3w-modellmotoren.de
0 rpm
1000 rpm
6000 rpm
10.000 rpm
to sensor
to battery
connection for red LED, long contact +
connection for 3W tachometer and other options
LED on
LED off - ignition ready for operation
LED on, ignition prepared but not ready for operation
two - cylinder
6,0 V
18 mA
20 mA
120 mA
1000 rpm
1100 mA
6000 rpm
1300 mA
10.000 rpm
> 20 kV
12.000 rpm
upper dead point
o
55
before upper dead point
0 rpm