Free The Tone ARC-4 Manuel du propriétaire - Page 13

Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} Free The Tone ARC-4. Free The Tone ARC-4 16 pages. Audio routing controller
Également pour Free The Tone ARC-4 : Procédures de mise à jour du micrologiciel (18 pages)

Imprimer la page
Free The Tone ARC-4 Manuel du propriétaire

Sending ARC-4's Data (DP-LD): ON/OFF switch 5

DP-LD
RECV
ENTER
PARAMETER
ENTER
 Turn the PARAMETER encoder to select "SEND."
 Press the ENTER switch to start data transmission when "YES" is shown.
 The display starts counting up when the data transmission starts.
Parameter: RECIEVE [RECV], SEND
NOTE
Before stating the data transmission, be sure to make the desitination ARC-4 ready to receive the data.
Initializing to Factory Reset Status (INITI): ON/OFF switch 6
INITI
YES
ENTER
ENTER
 Press the ENTER switch when "YES" is shown.
 When the process is in progress, "WAIT" is shown.
 When the Display-1 shows "DONE," the process is completed and all of the stored data is lost.
Updating Firmware via MIDI (FW-UD): ON/OFF switch 7
FW-UD
YES
ENTER
ENTER
The ARC-4 can update its firmware via MIDI. For the latest firmware or connection and setup procedures, please confirm with the product or support page of the
Free The Tone website.
24
YES
001
PARAMETER
ENTER
ENTER
WAIT
DONE
– – –
DONE

Using ARC-4 Efficiently

DONE

Connection Examples

Basic Connection

This is a basic setup in which one guitar and seven effects units are connected in series and one amplifier is used.
HTS
IN
TUNER
GUITAR
INITI
DIST

Using Two Guitars Separately

Use the separate loop (LOOP 8) as an input selector.
FW-UD
HTS
L8
DIST

Switching between Two Amplifiers

Use the separate loop (LOOP 8) as an output selector.
HTS
IN
COMP
GUITAR
DIST
L1
L2
L3
L4
L5
COMP
OD
DIST
TREM
CHO
COMP
OD
TREM
CHO
DLY
REV
AMP
LOOP 8 ON: Signals fed to R-8 are output from OUT-8.
LOOP 8 OFF: Signals fed to IN-8 are output from OUT-8.
L1
L2
L3
L4
L5
IN
COMP
OD
DIST
TREM
CHO
COMP
OD
GUITAR1 GUITAR2
TREM
CHO
DLY
REV
AMP
LOOP 8 ON: Signals fed to IN-8 are output from S-8.
LOOP 8 OFF: Signals fed to IN-8 are output from OUT-8.
L1
L2
L3
L4
L5
L6/A
OD
DIST
TREM
CHO
DLY
COMP
OD
TREM
CHO
L6/A
L7/A
OUT-A
AMP
DLY
REV
(Channel Switching)
To Amplifier Control
C1/C2 C3
Control
L6/A
L7/A
OUT-A
AMP
DLY
REV
L7/A
L8
OUT-A
AMP
REV
AMP
25