Free The Tone PA-1Q Series Manuel du propriétaire - Page 4
Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} Free The Tone PA-1Q Series. Free The Tone PA-1Q Series 6 pages. Programmable analog 10 band eq graphic equalizer
Imprimer la page
Recalling a Preset
The PA-1Q series can use up to 99 presets that can be recalled in various ways.
To switch among the first four presets:
1. Press the ON/OFF switch to turn on the LED above it.
2. Press the PRESET SELECT switch to switch the presets.
NOTE
Each press of the PRESET SELECT switch changes the presets as follows: PRESET 1 PRESET 2 PRESET 3 PRESET 4
PRESET 1, ...
To switch among the 99 presets:
1. Press the ON/OFF switch to turn on the LED above it.
2. Press the PRESET switch to flash the PRESET display.
3. Turn the PARAMETER encoder to show the preset to be recalled.
4. Press the PARAMETER encoder to recall the selected preset.
To switch presets via MIDI:
1. Connect an external MIDI controller to the MIDI IN terminal on the PA-1Q series rear panel.
2. Press the PA-1Q series ON/OFF switch to illuminate the LED above it.
3. From the external MIDI controller, send the MIDI program change number corresponding to the preset to be recalled.
NOTE
Be sure to set the same MIDI program change number on the sending device's MIDI channel and the PA-1Q series MIDI channel.
Setting up MIDI Receiving Channel P.6
When the PA-1Q series receive a MIDI program change number 001–004, the corresponding LED 1–4 above the PRESET SELECT
switch illuminates and the PRESET display shows the corresponding preset number (01–04). If a MIDI program change number 005
or later is received, then the LEDs 1–4 above the PRESET SELECT switch will not illuminate but the PRESET display shows the
corresponding preset number (05–99).
Setting Up MIDI Signals
The PA-1Q series can receive MIDI signals sent from an external controller to switch presets and edit
parameters.
To setup a MIDI receiving channel:
1. Turn on the power to the PA-1Q series while holding down the PRESET SELECT switch.
2. The PRESET display shows "CH ".
3. The LEVEL display shows the number of the MIDI receiving channel.
4. Turn the PARAMETER encoder to show the desired MIDI receiving channel.
5. Press the PARAMETER encoder to confirm the selected MIDI receiving channel.
NOTE
User editable parameters: ALL (Omni mode), 1–16 (MIDI receiving channel), OFF
6
Transmitting Data to/from an External Device
The PA-1Q series can save or recall preset contents to/from a personal computer. For connection and
setup procedures, please confirm with the product or support page of the Free The Tone website.
Updating Firmware
The PA-1Q series can update its firmware. For the latest firmware or connection and setup procedures,
please confirm with the product or support page of the Free The Tone website.
Initializing
1. Turn on the power to the unit while holding down the cursor key switch and PRESET SELECT switch.
2. The LEVEL display shows "1 n t".
3. Press the PARAMETER encoder to execute the initialization.
4. The PRESET display counts up from 01 to 99.
5. The LEVEL display shows the firmware version number.
6. All of the presets are returned to their factory default settings and usual operation resumes.
NOTE
This operation clears all of the presets and resets all of the settings to the default status as shipped from the factory.
PA-1QG (for Guitar) Factory Presets
Preset 1: Fat sound with emphasized mid-low frequencies
Preset 3: Sound for jazz play with reduced high frequency level
Preset 2: Sound for arpeggio with reduced mid range level
Preset 4: Sound with flat EQ but boosted volume
7