AudioCodes MP-504 Manuel d'installation du matériel - Page 12
Parcourez en ligne ou téléchargez le pdf Manuel d'installation du matériel pour {nom_de_la_catégorie} AudioCodes MP-504. AudioCodes MP-504 20 pages. Analog voice gateway
Imprimer la page
4. Mounting the Device
4.3
Wall Mounting
You can mount the device on a wall using the keyholes on the bottom of the device.
To mount the device on a wall:
1.
Drill three holes in the wall where you want to mount the device, using the distances between
the holes as shown in the figure below:
•
Horizontal distance between the top two parallel holes: 89 mm (5.51 in.)
•
Vertical distance between the top two parallel holes and bottom hole: 204 mm (8.03 in.)
•
Horizontal distance between a top hole and the bottom hole: 44.5 (1.75 in.)
◼
◼
2.
Insert wall anchors of the appropriate size into each hole.
3.
Thread screws (not supplied) into each of the wall anchors. The recommended screw type is
DIN 7982 3.5x25 Phillips flat head. Make sure that the heads extend sufficiently (about 4 mm
or 0.157 in.) from the wall for the device's keyholes to hang on:
Figure 7: Dimensions for Drilled Holes
When choosing the area on the wall to mount the device, make sure that sufficient
space is available for attaching cables on the rear panel.
Make sure that you drill the holes in the same orientation as shown in the above
figure (i.e., two parallel holes on the top and the single hole on the bottom).
- 12 -
MP-504/8