Freecast CP7039 Manuel de l'utilisateur - Page 3

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Freecast CP7039. Freecast CP7039 7 pages.

Freecast APP installation

Please scan the QR code as below or search "Freecast " APP in APP store.

Please note that the Freecast installedIphone / IPad CPU model requires A7 and above,

and the operating system version requires iOS 8.0 and above.

Batter y charge

Both the transmitter and receiver use Model No. 14500 cylindrical lithium batter y.

The batter y should be fully charged before it is first used.

If you use fully-charged 14500 new batteries (3.7V, 800mAh), the duration of

transmitter will be 90 minutes and the duration of receiver will be 80 minute.

After repeated charge and discharge, the batteries efficiency will reduce for

which will lead to short duration time of batteries.

Precautions:

1. The nominal voltage of lithium batter y 14500 is 3.7V and the maximum capacity is

800mAh, but some of the 14500 batteries in market are exaggerated in actual batter y

capacity, so please choose carefully.

2. The lithium batter y 14500 needs to be used in pairs and do not mix new batteries in

use with used batteries, other wise it will be shorten the use life of new batteries.

How to install batter yof the

transmitter and the receiver

Please pinch the paddle on the side of the productand take out the batter y box,

and please refer to the silk-screen direction in the batter y box before putting

2 lithium batteries in.

Please note!

That the lithium batter y installed in the opposite direction will cause the product

to fail to power on,but will not cause damage to the product.

Antenna installation of the

transmitter and the receiver

The product is provided with 4 antennas, please screw the antenna to the antenna

connector on the top of the transmitter and receiver.

Notification!

Please make sure the transmitter and receiver 's antennas are vertical upwards

when using the product to ensure high transmission performance of wireless signal.

How to install camera to the transmitter

Please use the screw lock HDMI cable supplied with this product, connect the

transmitter to Gopro Hero 5 or other cameras with HDMI output interface.

Screw lock HDMI cable