Danfoss 4MFCE1-12CUP15L Manuel d'installation - Page 7

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Danfoss 4MFCE1-12CUP15L. Danfoss 4MFCE1-12CUP15L 10 pages. Multiplate coupling

Imprimer la page

Perform following steps for assembly of socket half (female) coupling in fixed plate:

A. Disassemble socket body from rest of the sub-assembly.

B. Insert socket body in respective hole in fixed plate such that shoulder of the socket body is rested against

counter-bore in plate.

C. Align semi-circular slot on socket body with that on fixed plate by rotating the body.

D. Insert standard 4 mm dia. pin / tool in this slot after alignment to block the rotation of socket body.

E. Insert sub-assembly into socket body from bottom side, and screw threads in clockwise direction.

F. Using standard wrench, hold hex on end connection of coupling and rotate in clockwise direction to apply

torque as per below chart.

Co u p l i n g s e r i e s

Co u p l i n g s i z e

FF (ISO 16028)

ISO 6

FF (ISO 16028)

ISO 10

FF (ISO 16028)

ISO 12

FF (ISO 16028)

ISO 16

FF (ISO 16028)

ISO 19

FF (ISO 16028)

All

8.2

PLUG HALF REPLACEMENT

Figure 4. Plug (male) half assembly on movable plate

Plug (Male) half assembly on movable plate comprises of 2 sub-components:

1. Plug (Male) assembly

2. Jam Nut

Perform following steps for removing plug half (male) coupling from movable plate:

A. Hold Nut in position by inserting a standard tool in slots provided on top surface, as shown in

Figure 4 Jam Nut view.

B. Using standard wrench, hold hex on end connection of coupling and rotate in counter-clockwise

direction to unscrew the sub-assembly.

C. Remove plug assembly and Jam Nut from movable plate.

Co u p l i n g h a l f To r q u e i n N - m

Socket

100

Plug