Audiocom PS-4001 Instructions pour l'utilisateur - Page 4

Parcourez en ligne ou téléchargez le pdf Instructions pour l'utilisateur pour {nom_de_la_catégorie} Audiocom PS-4001. Audiocom PS-4001 6 pages. Telex power supply user manual

Imprimer la page

Operation and Specifications

Universal AC Power Input: The unit accepts any input power in the range opf 100-240 VAC, 50/60 Hz.

Connector to ES-4000A: This connector carries power to the ES-4000A expansion station, and carries the four audio

channels of the ES-4000A. When a Telex ES-4000A is connected to the PS-4001, each of the four channels of audio is

"broken out" to the respective channel connections.

Intercom Channel Connectors: These connectors carry power to the intercom system and provide termination for the audio

signal of each individual intercom channel.

Channel Status Indicators: The indicators are green for normal operation and red when there is an overload or short circuit.

The circuitry in the unit will automatically reset when the overload or shirt circuit is located and fixed, and the LED will go

back to green.

BAL/UNBAL Selector Switch: This selector switch allows the user to configure the unit for use in either an Audiocoom

(BALANCED) or ClearCom

power requirements, and call signaling requirements. The default setting for this switch is in the Audiocom

position.

Specifications

GENERAL

Input Power Requirements: 100 to 240 VAC, 50/60 Hz

Output Power (each channel): 24 ±1 VDC, 1 Amp per channel

Dimensions: 1.75" (44.5mm) high x 8.25" (209.5mm) wide x 10.31" (261.9 mm) deep

Weight: approxiamately 2.5lb. (1.13 kg)

Environmental Requirements:

Storage: -20°C to 80°C, 0% to 95% humidity, non-condensing

Operating: 0°C to 50°C, 0% to 95% humidity, non-condensing

INTERCOM CHANNELS - General

Connector Type: One XLR-3M audio connector for each channel. Pin-out depends on setting of BAL/UNBAL switch for

balanced or unbalanced operation as defined below:

Balanced Mode (Set to BAL position)

Line Terminating Impedance: 300 Ohms ±10%

Connector Pinout

Unbalanced Mode (Set to UNBAL position)

Line Terminating Impedance: 150 Ohms ±5%

Connector Pinout

APPROVALS

UL, CUL, CE

(UNBALANCED) system. Compatibility includes channel connector pin-outs, channel

Pin 1

Common (audio and DC return)

Pin 2

Full-Duplex, balanced intercom audio and +24 VDC output

Pin 3

Full-Duplex, balanced intercom audio and +24 VDC output

Pin 1

Common (audio and DC return)

Pin 2

+30 ±1 VDC output

Pin 3

Full-Duplex, unbalanced intercom audio high

(BAL)