Dupline Carpark GP 7380 0080 Manuel de démarrage rapide - Page 5
Parcourez en ligne ou téléchargez le pdf Manuel de démarrage rapide pour {nom_de_la_catégorie} Dupline Carpark GP 7380 0080. Dupline Carpark GP 7380 0080 5 pages. Configuration and test unit
Imprimer la pageMode of Operation
(X = Group number,
Y = Channel in-group X).
Press « Mode/Enter » when the want-
ed channel is selected.
Select calibration channel
Fig. 25
3. When the channel has been select-
ed, an intermediate state is entered:
" PRESS ENTER TO CALIBRATE!"
Press « Mode/Enter » to start Calibrat-
ing.
Start calibration
Fig. 26
4. When « Mode/Enter » is pressed the
calibration is started and a progress
bar is shown in the display:
"0%: ************************: 100%
dditional Information
Scope of supply:
1 x Conf./Test unit
1 x Programmer cable
1 x Test cable
Specifications are subject to change without notice (12.12.2008)
Dupline
®
is a registered trademark. A product of the CARLO GAVAZZI Group
Calibration in progress
Fig. 27
Don't press anything the GTU will
change state automatically.
5. When calibration is finished the fol-
lowing will be shown in the display:
"FINISHED! PRESS « Mode/Enter » TO
EXIT"
Pressing the « Mode/Enter » button is
the only way to restart calibration or
entering a new mode of operation!
Warning:
Do not plug in the Jack connector
when it is connected to Dupline
the configuration unit is ON. This will
cause a short-circuit of the two wires.
Note:
If the Dupline
display will come up with the text
shown in Fig. 28
After a few sec. the display will turn
off, if nothing has been done or any
buttons has been pressed
GP7380 0080
GAP CAB
GTU8 GRIP CAB
®
and
®
carrier is missing, the
Du line
Fieldbus
Installationbus
Config unit (Both Sensors, Master and
Slave units)
Fig. 28
Low Battery
If, when activating the Configuration
and GTU Unit, " * LOW BATTERY * " is
showed in the display, it is time for
changing the battery. The unit will con-
tinue to work, but it is recommended
that the battery is changed. The bat-
tery is changed by dismounting the 4
screws on the back of the unit and
removing the back cover. After that,
take out the PCB, change the 9V bat-
tery and then reassemble the unit.
®
5