Conqueror CIL-CD800S Manuel du propriétaire - Page 5
Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} Conqueror CIL-CD800S. Conqueror CIL-CD800S 14 pages. Chain and belt openers
Imprimer la pagewww.conquerordoors.com
3. Opener Installation
3.1. Important installation instructions
In order to reduce the risk of serious injuries or death, please read and follow all
instructions provided!
1) Install only on a properly balanced door. An improperly balanced door has the potential
to inflict severe injury. Have a qualified service person make repairs to cables, spring
assemblies, and other hardware before installing the opener!
2) Remove all ropes and remove or make inoperative all locks connected to the garage door
before installing opener!
3) Where possible, install the operator at least 2.1 meters or more above the floor. For
products having an emergency release, mount the emergency release at least 1.8 meters
above the floor!
4) Locate the control button:
• Within sight of door
• At a minimum height of 1.5 meters so children are not able to reach it, and
• Away from all moving parts of the door
5) This operator is to be used only with residential sectional or one-piece doors!
6) To avoid damage to the garage door and operator, disable any door locking mechanisms
before installing and operating the operator.
7) Prior to installation ensure that all fixing points where screws and bolts will penetrate
through walls or ceilings that no electrical, gas or water lines are in the way or may come
into contact with.
8) The garage ceiling must have installed appropriate timber fixing points. The installer
must ensure that the operator is firmly attached and is not screwed into only gypsum or
plaster ceilings which are not alone structurally appropriate for fixing to.
9) The enclosed emergency release rope must be installed at a convenient height, and not at
a level that will interfere with vehicles moving in and out of the garage! Check the
emergency release operation after installation to ensure ease of operation.
10) Do not use the emergency release rope to open or close the door!
11) After installing the opener, check that the door automatically reverses when it comes into
contact with a 40mm high object on the floor during the closing sequence!
12) All electrical terminations involving mains voltage (240VAC) must be performed by a
qualified electrician. This includes the installation of the 3 pin socket. The automatic
operator comes supplied with a fixed 1 meter long power cord with a standard 3 pin plug
attached, so can be plugged directly into a standard 10 Amp power socket or extension
cord if required.
13) Any low voltage ancillary device connections can be performed by the homeowner or
qualified installer. These include safety beams, alarm control systems, wired wall control
switches etc.
For garages without a second access door or internal access, an additional emergency
release is necessary, which prevents a possible lock out!
2