Dura Faucet DF-NML202 Manuel de démarrage rapide - Page 3

Parcourez en ligne ou téléchargez le pdf Manuel de démarrage rapide pour {nom_de_la_catégorie} Dura Faucet DF-NML202. Dura Faucet DF-NML202 6 pages. Single lever arc rv bathroom faucet

Imprimer la page

INSTALLATION OF THE FAUCET

New Faucet Installation

Shut off the water supply and remove the old faucet by disconnecting it from the supply

tubes under the sink, and unscrewing the faucet from the countertop by removing

mounting nuts. Clean the sink top surface in preparation for the new faucet. If you are

fastening the deck plate to your faucet apply plumbers putty, or other suitable sealant,

to the bottom edges of the base plate. Once applied, align the base plate and press into

place to firmly attach to sink. When finished, remove any excess plumbers putty and

place deck plate into base plate.

Install Faucet on Sink Top

Remove both the locknut and washer provided. Place the faucet on the sink and feed

the hoses down through the center hole in the sink. From below secure the faucet by

reattaching the locknut and washer and screw down until they are tight. Make sure that

you tighten the locknut before the screws.

Drain Installation

Remove the stopper from the drain and unscrew the drain from the plastic pipe. Remove

plastic locknut, washer, and rubber seal from the drain. Apply plumbers putty or silicone

sealant to the bottom edges of the drain. Once applied, press firmly into place (Note:

there should be excess plumbers putty pushing out from the edges. This can be removed

later). Attach the rubber seal, washer, and locknut back onto the bottom of the sink.

Once applied, attach the plastic pipe with the retaining nut attached and screw into

place.

Install Horizontal Pivot Rod

Remove the retaining nut while being sure to leave the plastic ring inside. Next, remove

the metal spring attached to the horizontal pivot rod, ball first, into the pipe, and feed the

retaining nut over the rod and lightly attach without tightening.