audiomotion electronics Just Ultra Bikes Meso Manuel du propriétaire et de l'utilisateur - Page 9

Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire et de l'utilisateur pour {nom_de_la_catégorie} audiomotion electronics Just Ultra Bikes Meso. audiomotion electronics Just Ultra Bikes Meso 11 pages.

Imprimer la page
MESO : TYRE MAINTENANCE
Flat Tyre
If you get a flat tyre, remove the wheel. Depress the tyre valve to let all the air out of the tube. Remove
one bead of the tyre from the rim by grasping the tyre at a point opposite the valve stem with both hands
lifting and peeling one side of the tyre of the rim. If the bead is on too tight for you to unseat it with your
hands, use tyre levers to lift the bead carefully over the tyre rim. Push the valve stem through the wheel
rim. Remove the inner tube.
Carefully check the outside and inside of the tyre for the cause of the puncture and remove the cause if it is
still here. If the tyre is cut, line the inside of the tyre in the area of the cut with some handy-tape, a spare
patch, a piece of inner tube, or whatever will keep the cut from pinching the inner tube.
Either patch the tube (follow the instructions in your patch kit) or use a new tube. Reinstall the tyre and
tube. Slip one tyre bead over the rim. Insert the tube valve through its hole in the rim. Feed the tube
carefully into the cavity of the tyre.
Inflate the tube just enough to give it some shape. Starting at the valve stem use your thumbs to seat the
tyre bead inside the rim. Work your way around both sides of the wheel until the entire bead is seated in
the rim. Be careful not to pinch the tube between the tyre bead and the wheel rim. If you have trouble
getting the last few inches of bead over the edge of the rim with thumb pressure, use a tyre lever and be
careful not to pinch the tube. To avoid punctures we recommend slime tyre sealant or similar.
Check to make sure the tyre is evenly seated around both sides of the rim and that the tube is inside the
tyre beads.
Push the valve stem into the tyre to make sure that the base is seated within the tyre's beds. Inflate the
tube slowly to the recommended pressure, all the while checking to make sure that the tyre beads stay
seated in the rim. Replace the valve cap and re-install the wheel.
WARNING
Riding your E-bike with a flat or under-inflated tyre can damage the tyre, tube and E-bike, and can cause
you to lose control. Please ensure that your tyres are inflated to the correct PSI indicated on the tyre
Please visit
www.justultrabikes.com
to activate your warranty.
MESO GETTING STARTED : MAINTENANCE CHECKLIST
Component or Condition
Inspect
before
every ride
Tyre pressure
√
Tyre wear or damage
√
Brake pad adjustment
√
Handlebar quick release
√
adjustment
Controls and displays
√
Seat post quick release
√
adjustment
Brake pad wear
Brake cable tension
Wheel true
Hub bearings
Chain lubrication
Derailleur adjustment
Reflectors
Battery and charger
Headset
Bottom bracket
Inspect
Clean
Adjust or
periodically
and/or
Tighten
lubricate
√
√
√
√
√
√
√
√
√
√
√
√
√
√
√
√
√
√
√
√
√
√
√
√
√
Repair or
replace if
necessary
√
√
√
√
√