audiophony CR120A-U1 Manuel de l'utilisateur - Page 6

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} audiophony CR120A-U1. audiophony CR120A-U1 14 pages. Bluetooth sound system with usb player & 1 handheld mic

Imprimer la page
English

4 -Description of the modules

4 - 1 : UHF receiving module
5
6
RF
AF
DOWN
UP
MUTE LEVEL
4
3
2
7
4 - 2 : USB/SD/Bluetooth
2
1
st
®
1
Bluetooth
pairing:
Switch to Bluetooth
mode. The display will indicate «BT NOT LINK», then «connecting...» for a few seconds.
®
Turn your Bluetooth
source ON and scan for devices.
®
Select «Bluetooth» in the list, and accept the pairing.
The CR120A-U1 display should indicate the name of the connected device.
Page 6
120W B
CR120A-U1 -
A1 - Volume control fader for the HF module. From OFF to full power
(clockwise).
8
9
A2 - Squelch control fader: allows you to configure the threshold in
case of HF signal interruption. The factory settings do not require
any modification.
A3&4 - Canal selection: allow you to browse through the 16
available frequencies.
IR
A5 - Frequency display.
8
A6 - Radio Frequency indicator: this indicator is lit in red when the
emitting mic is ON.
4
12
A7 - Audio Frequency indicator: this indicator is lit in green when a
signal is being received.
OFF
15
POWER-VOL
A8 - ASC (Auto Synchro Connection) button: allows you to
synchronise a channel between the transmitter and receiver. Select
1
a channel (from 1 - 16), press the ASC button and put the IR (#6)
diode of your mic in front of the IR (#9) diode of your receiver.
A9 - IR diode. Allows you to synchronise your mic with the receiver.
module
®
3
6
®
LUETOOH
SOUND SYSTEM WITH
4
5
USB
1
PLAYER AND
UHF HANDHELD MIC
B1 - Channel 1 input selector. Allows
you to decide if the player or the Aux
input will be active on channel 1 of the
mixer.
B2 - SD card slot.
B3 - Reader display.
B4 - IR diode to receive the remote
control commands.
B5 - USB mass storage socket for
USB key.
B6 - Command panel of the reader:
MODE:
Allows you to switch from USB/SD to
the Bluetooth
receiver: the display
®
will indicate «BT NOT LINK», and
«connecting» for a few seconds when
you switch to Bluetooth
MODE.
®