Console Customs RFP-R1 Instructions de programmation - Page 2
Parcourez en ligne ou téléchargez le pdf Instructions de programmation pour {nom_de_la_catégorie} Console Customs RFP-R1. Console Customs RFP-R1 2 pages. For sony playstation 3
Imprimer la pageChanging the User adjustable rapid fire speed
These instructions are also available as a video from our website
our youtube page www.youtube.com/consolecustoms.
1. First your controller needs to be turned OFF and also not plugged into any sync or charging
cable.
2. With the controller OFF, press and hold the mode/speed change button on the back.
3. While holding the mode/speed change button, press the PS button to turn your controller ON.
You will see the player 4 LED come on for 1.5 seconds then go out. After you see this you
can release both buttons. You are now in the programming mode.
4. When you enter the programming mode the user programmable speed is set back to 6 shots
per second (166 milliseconds per sot). This is so you always know where you are at and also
allows the programming to be done with only using one button.
5. While in the programming mode every time you press the mode/speed change button on the
back of the controller the firing rate will increase by 2ms. The player 4 LED will also flash.
The rate can be increased until you reach 25 shots per second ( 40 milliseconds per shot). At
this point the player 4 led will not flash and pushing the button will no longer increase the
speed.
6. At any time you can test you speed by just pressing R1.
7. Once you are at the desired speed you can save and exit programming mode by holding in
the mode/speed change button for 3 seconds. After doing this you will see the player 4 LED
flash for 1.5 seconds and then go off. You will now be back on the normal firing mode. The
controller will return to the game mode you were previously in.
Tips:
• Every time you enter the programming mode the speed is set back to 6 shots per second (166
milliseconds per sot)
• Remember or better yet write down the number of times you pressed the button. So you can go
back and make adjustments if needed.
• This mode works in milliseconds each time you press the button the speed is decreased by 2ms. So
you can easily calculate you speed.
• The default is 6 shots per second or 166ms. There are 1000 milliseconds in 1 second. So
1000/166 = 6.02 or approximately 6 shots per second.
• If you press the button 20 times you are now at 126ms. 1000/126 = 7.94 approximately 8
shots per second.
• If you want to go slower in speed you must exit and re-enter the programming mode and start over.
Since there is only one button you can only make the rapid fire faster from the default 6 shots per
second.
www.consolecustoms.net
and also