Audiophony PA MX82 Manuel de l'utilisateur - Page 13
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Audiophony PA MX82. Audiophony PA MX82 17 pages.
Imprimer la pageMX82 - Multizone and rackable Mixer/Pre-amplifier with 8 inputs and 2 outputs
1
REAR PANEL
1
2
3
4
1
Power input
Connect here the supplied IEC power cord, then
connect the other end to an electrical outlet after having
checked the voltage.
2
DC24V connector
The PREZONE444 might be set up in a public place and
used as an alert center in case of emergency. To this
effect, it features a 24V back-up power supply unit.
3
REMOTE MIC
Allows you to connect the MIC-DESK4 announcer.
Thanks to your MIC-DESK4, you can individually select
each zone for public announcements.
4
PRIORITY INPUT
This input has priority over all others. If a signal is
present on this input, all other inputs are muted.
5
EXT. MUTE connectors
These connectors are used to connect a contact to
mutethe corresponding output.
6
Outputs STEREO/MONO switches
These switches allow the stereo inputs to be summed
into two identical channels.
7
Line outputs
Connect an amplifier to these outputs to power
speakers.
The signal level on these outputs is adjustable on the
front panel via the potentiometers of the OUTPUT 1 and
OUTPUT 2 zones.
8
3 to 8 input connectors
These inputs are stereo line level.
The signal volume present on these inputs is adjustable
on the front panel.
All manuals and user guides at all-guides.com
2
5
6
7
3
9
8
12
9
STEREO/MONO inputs switches
These switches allow a mono signal present at the input
to be sent on both the right and left channels of the
outputs.
10
1 and 2 channels equalization
These channel features a 3-way signal equalization.
These knobs allow you to increase or decrease basses
(LOW), mid frequencies (MID) and trebles (HIGH) of each
incoming signal.
Microphone channels only feature these settings.
- HIGH (High Frequency control): Allows you to
adjust
trebles of the corresponding channel from -15 to +15 dB
at 12kHz.
- MID (Mid frequency control): Allows you to adjust mid
frequencies of the corresponding channel from -15
to +15 dB at 2.5kHz.
- LOW (low frequency control): Allows you to adjust
basses of the corresponding channel from -15 to +15 dB
at 80Hz.
11
GAIN potentiometer
These potentiometers on all inputs allow you to adjust
the level of the incoming signal on each input.
12
1 and 2 input connectors
These connectors are used to connect line or
microphone level signals.
13
PHANTOM switches
These switches allow you to add +15V DC phantom
power to microphone channels 1 and 2 in order to
connect condenser microphones.
14
TALKOVER switches
These switches are used to attenuate the signals on
inputs 3 to 8 when a signal is present on inputs 1 and 2.
English
4
10
11
13 14
Page 13