Audiopipe APSM-1500 Manuel du propriétaire - Page 6
Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} Audiopipe APSM-1500. Audiopipe APSM-1500 14 pages. Mini design class d mosfet car amplifier
Imprimer la page
We recommend you have the installation done by an Authorized Audiopipe Dealer.
Required power, ground wire and proper external fuse as below:
Model
APSM-1300
APSM-1500
APSM-2000
We recommend the fuse should be installed no more than 12 inches from the battery.
The ground wire should be connected directly with the chassis of your vehicle which should
be metal to metal ground point connection. The amplifier must be mounted securely at a
solid, dry and low vibration surface in the trunk or passenger area. Mount the amplifier
in an open air area to insure proper heat dissipation. Mount the amplifier in a place where
can access easily to set the input controllers. Install all amplifier cables as far as possible
from car electrical cables such as the car ignition cable.
IMPORTANT:
•
When bridging two amplifiers please refer the bridging wiring chart.
•
When bridging two amplifiers you should use same model amplifiers.
•
Please make sure the negative speaker terminal of two amplifiers are connected by the
same gauge cables as the positive terminal being used.
•
DO NOT connect any signal cables with the input RCA jacks when bridged as slave unit.
•
The LPF, Input level and remote functions will be disabled on slave amplifier when
bridged.
•
All the functions of the slave amplifier will be adjusted by the master amplifier.
Fuse
80 AMP
100 AMP
150 AMP
Wire
4 Gauge
2 to 4 Gauge
0 to 2 Gauge