Beldray EH0089 Manuel d'instruction - Page 9

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} Beldray EH0089. Beldray EH0089 15 pages. Conception wall fire

Imprimer la page

30 mm

STEP 4: The wall bracket needs to be mounted approximately 30 mm inwards from the outer

edge of the fire surround. Hold the wall brackets in this position and carefully mark the

positions of the screw holes.

STEP 5: Drill where the holes have been marked, then insert the wall plugs.

STEP 6: Screw the wall brackets into place.

STEP 7: Hold the Conception Wall Fire above the brackets, leaning it against the wall for support.

STEP 8: Carefully lower the Conception Wall Fire onto the brackets so that the fireplace rests

on the hearth.

STEP 9: Using a pencil, draw a line approximately 100 mm along the wall against the edge of

the hearth, starting from the outer right hand side of the Conception Wall Fire. Repeat

this at the left side of the fire. This will mark the height of the hearth against the wall as

well as where the corners of the Conception Wall Fire will sit.

STEP 10: Remove the Conception Wall Fire by lifting it from the wall mounting brackets and

then remove the hearth.

STEP 11: Using the lines drawn onto the wall as a reference, drill a hole in the centre, 20 mm

below the base of the Conception Wall Fire.

STEP 12: Insert the wall plug into the hole.

STEP 13: On the Conception Wall Fire, insert the t-shaped bracket into the recess in the

bottom centre of the front panel. They should hang below the Conception Wall Fire.

STEP 13: Refit the Conception Wall Fire onto the wall brackets, ensuring that it does not drop

below the baseline previously marked.

STEP 14: Screw the t-shaped bracket to the wall.

STEP 15: Slide the hearth back into place underneath the Conception Wall Fire.

Note: It may be necessary to lift the fire slightly whist fitting the t-shaped bracket.

EH0089 Conception Wall Fire