Consort CRXLC Manuel d'installation et d'utilisation - Page 2

Parcourez en ligne ou téléchargez le pdf Manuel d'installation et d'utilisation pour {nom_de_la_catégorie} Consort CRXLC. Consort CRXLC 2 pages. Single zone landlord wireless controller

Imprimer la page

5. Heat symbol on the display

Every time there is a demand for heat, the display will show

the heat icon.

- reduced heat output when the room temperature is

close to the set temperature.

- full heat output

6. Status light on the heater

Light colour

7. Power options

The CRXLC controller can be powered either by a 5V power

adapter with a micro USB connector, supplied power

adapter via USB port or 4 AAA batteries. There are 2

available USB ports for power. One port is located on the

bottom and one at the back of the controller.

8. Batteries

Remove the CRXLC's battery cover and insert 4 new high

quality alkaline AAA batteries.

Warning: Consort is not responsible for damage due to

corrosion. Battery leakage will cause permanent damage.

Do not use batteries when unit is powered on with mains.

To help avoid battery leak:



Replace the batteries annually, even if there is not a

low battery warning. Remove failing or flat batteries

immediately.



Always fit a pair of new high quality alkaline batteries

from the same pack. Never mix new and old batteries,

or batteries of different brands or types.



Never attempt to revive alkaline batteries by heating,

crushing or recharging.

Issue 01

Heater status

STAND-BY No heat output

Reduced heat output

Full power heat output

Heater is ready for pairing with CRXLC

FAULT - Overheating

FAULT - Connection with CRXLC lost

9. Power adapter for fixed installation

The CRXLC controller is supplied with a power adapter that

will fit a 35mm or a 25mm metal or dry lining back box. The

power adapter should only be connected to a wiring

protected by a 3A fuse. Connect line and neutral conductors

to the terminal block. Please note that the adaptor supplied

with the controller must be installed exactly as the figures

show, otherwise the USB connector will not fit correctly. The

centre of the back box must be kept clear to allow room for

the USB connector.

When fitting the wall bracket, ensure that the adaptor is

installed properly and feed the cable through the centre of

the bracket. Screw the bracket to a back box taking care

not to damage the power adaptor or leads by long screws.

Connect the USB cable into the power port at back of the

controller as shown on the photo. Check that the CRXLC is

working. Attach top of the CRXLC to the wall bracket and

slowly tilt it to place observing that the USB connector is

moving in to the opening freely. Once the controller is in

place secure the two screws on the bottom of the controller.

Please note that the controller screen will take up to

one minute to display after powering up for the FIRST

time.

wall fixing

locking screws

USB power ports

temperature sensor

wall fixing