Constellation Pictor Manuel du propriétaire - Page 11

Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} Constellation Pictor. Constellation Pictor 17 pages. Line stage preamplifier

Imprimer la page

Remote control

The remote operates the basic functions of the Pictor. It does not operate Constellation source devices, such as

the Perseus phono preamp and the Cygnus digital file player.

18. Standby

Push this button to turn the Pictor on

and off. When you turn the unit on, it

will take a few seconds for the unit to

warm up. When the amp is ready for

use, its LCD screen will show the most

recently selected input. To put the unit

in Standby mode, press this button

again after turning on the power.

Hold this button down for 5 seconds to

turn the integrated amp off. The unit

will enter cool-down mode for 10 sec-

onds. During cool-down, no buttons on

the unit or remote will operate.

19. Mute

Press this to button to silence the Pictor

temporarily. The numerical volume

readout will flash. Press again to re-

store the audio. Because the Pictor uses

relay to perform the mute function, it

may take a second or so for this control to respond.

20. Volume up/down

Press these buttons to raise or lower the volume. Each press changes volume by 1 dB at volumes below -50.0 dB,

and 0.5 dB at volumes above -50.0 dB. Holding the buttons down raises or lowers the volume quickly.

21. Balance left/right

Press these buttons to shift the balance to the left or right. Each press changes the balance by 0.1 dB.

22. Input

Press this button to select among the Pictor's XLR and RCA inputs. You will have to wait a second or so be-

tween pushes of this button, because for best sound quality the Pictor uses relays to switch inputs.

23. Headphones

Push this to activate the headphone output. This will mute the sound from the speakers. To restore the sound in

the speakers, push the headphones button again.

NOTE:

The remote uses a single CR2032 battery, which should last about a year under normal use. If the am-

plifier does not respond to the remote, use a 7/64" allen wrench to remove the back cover, remove the old batter-

ies, and install a fresh CR2032 battery.