DanVex AD-10000 Manuel d'utilisation - Page 8

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} DanVex AD-10000. DanVex AD-10000 18 pages. Adsorption air dehumidifier

Imprimer la page

Technical data of AD-10000

Parameter

Dehumidified air*

Rated air consumption

Pressure

Reactivation air*

Rated air consumption

Pressure

Electric power and rated current

Total power

Voltage (3 phase, 50 Hz)

Reactivation air heater

Heater capacity

Heater type

Miscellaneous data

Maximum sound pressure level

Operational temperatures range

Standard filter: dehumidified air

R eactivation air

IEC protection, the whole dehumidifier

The above mentioned values are nominal based on the air temperature of 20 С and the air density of 1,2kg/m

Commissioning

Start up procedures:

1. Make sure the dehumidifier is disconnected from the power supply source and that its main

switch is in OFF position.

2. Open the dehumidifier service panels and make sure there are no foreign matters inside

the dehumidifier.

3. Make sure all air throttles are opened and that channels are clean and not blocked.

4. Make sure that air filters are installed and clean.

5. Manually turn the fans impellers and make sure they rotate freely.

6. Check the internal fuse.

7. Close the service panels and connect the dehumidifier to 380/400V power supply.

8. Switch on the dehumidifier power supply. The following will be displayed on the control

panel LCD:

Unit

m /hour

dB(A)

Table 2

Value

10000

500

3500

250

380/400

Tubular Heating Element

–20...+40

EU3

IP44