Beliani WEBER Mode d'emploi - Page 3

Parcourez en ligne ou téléchargez le pdf Mode d'emploi pour {nom_de_la_catégorie} Beliani WEBER. Beliani WEBER 4 pages.

Imprimer la page

4.MOUNTING BRACKET INSTALLATION

CAUTION:

Do not install mounting bracket on the

roof with leaking and damp problem. The ceiling must be

able to withstand the weight of 40 kg or more, in order to

prevent the top of the danger that smallpox drop off .

CAUTION:

Do not install on an uneven ceiling, and

ceiling mounted hanger must be fixed firmly to ensure

not be loose.

-3-

Concrete ceiling:Drill two holes with an

appropriate depth by a drilling bit with dia. at

8mm² and insert two pieces expansion screws

in the holes, then fix the hanger bracket into the

expansion screws with the wood screws and

tighten it by nuts of the expansion screws.

Wood ceiling: Fix the mounting bracket to the

wood ceiling with(thickness at 7cm at least) by 4

wood screws.

5. INSTALLATION OF THE CEILING FAN

1. Insert downrod over upper canopy,

then insert the cross pin over yoke

& Cotter pin and fasten the screws

which fix the downrod.(Fig.1)

2. Install the mounthing plate by screws.

(Fig.2)

3. Loose the screw from motor.(Fig.3)

4. Install the blades on the motor by

screws.(Fig.4)

5. Make sure the fan is disconnected

from the electrical supply and

carefully insert the fan into the

mounting bracket. Rotate the fan until

the notch of the hanger ball engages

the pin of the mounting bracket. Then,

firmly fix the screws.(Fig.5)

6. Assembly the LED light plate to the

light kit fixing bracket by the screws

and connect the LED light kit by male

& female plug. Insert the remote

control receiver on the mounting

bracket. Connect the motor wires, LED

light wires and receiver's power

wires to the receiver by male &

female plug.Also, connect the ground

wire by male & female plug.Then

connect the power supply with the

fan.(Fig6)

7. Assembly the shade to the light plate

and assembly the upper canopy to

the mounting bracket. Both rotate

clockwise when assembling.(Fig.7)

8. Now, the fan is completed.(Fig.8)

-4-