Addonics Technologies DDU3SAS Manuel de l'utilisateur - Page 3

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Addonics Technologies DDU3SAS. Addonics Technologies DDU3SAS 6 pages. 1:3 blu-ray / dvd duplicator

Imprimer la page

12.19 Quick Compare

Quick Compare is related to function#5 Compare. Once compare error byte reach to the setting

figures, compare process will stop.

12.20 Link Mode Select (Select Models)

Now press ESC and ▼ to enter the following screen. Press ENT to enter the "Link Mode Select"

screen. Use ▲ ▼ to choose between the Stand Alone, Middle Tower or Last Tower modes as

appropriate.

Attention: Once a tower has been set as Middle Tower or Last Tower and the J14 jumper is also set

to Target mode, the LCD will show that it is in Target mode.

12.21 Re-Scan (Select Models)

Now press ESC and ▼ to enter the following screen. Press ENT to enter the "Re-Scan" screen. By

default this is set to No. Use ▲ ▼ to choose Yes then press ENT to scan the chosen connected

tower.

12.22 Tray-In/Out

Lets you control the drive tray ejecting. The default is All Once and there have Divide 2 Times for

selection. The default is 5 second, more option is up to 99 seconds.

12.23 BootTime Delay

To set the device scanning time during the system booting.

12.24 Start Tray Eject

To set if do eject all tray after system boot up. The default is On. Press ▼ to select Off.

12.25 Disc Redetect

The function is designed specially for bad quality disc, the system will detect the disc one more

time if disc recognition error occurred. The default is Off. Press ▼ to select On.

12.26 Show Burn Speed

Now press ESC and ▼ to enter the following figure. This function lets LCD shows the burning

speed of CD/DVD/BD writers. The default is On. Press ▼ to select Off.

Technical Support:

Hours: 8:30 am - 6:00 pm PST

Phone: 408-453-6212

Email: http://www.addonics.com/support/query/

Quick Guide

Installing the 1:3 optical duplicator

Step 1

Insert the 1:3 Blu-Ray / DVD Duplicator into standard 5.25" drive bay.

Step 2

Connect the power cable from you system to the 4-pin floppy power connector.

Step 3

Connect the source drive to the source SATA port via SATA cable and the target

drives to the destination SATA port via SATA cable.

Step 4

Screw the duplicator into the drive bay with 4 screws (2 on each side).

Duplicating drive(s)

Make sure the source and target drives are connected to the proper ports.

When the duplicator is on, it will go through the steps below.

Step 1

Duplicator LED will light up and the device will beep.

Step 2

LCD will display initial steps:

1. Duplicator Ver: - Displays duplicator version

2. Initializing SDRAM

3. Detect Source/Target - Will detect the type of source/targets

4. Copy - Defaults to the first function which is to copy

Step 3

Once the duplicator gets to the copy menu, press ENT to begin copying. The

duplicator will auto-detect the drive and display its information on the LCD. Make

sure that the power LEDs of the flash reader are blinking, the blinking indicates

drive activity.

You can find the complete user manual of the 1:3 Blu-Ray / DVD Duplicator panel

on the driver disk under user guides. You can also download it from our website at