AudioSource PSW100 Manuel de l'utilisateur - Page 3
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} AudioSource PSW100. AudioSource PSW100 5 pages. With active crossover
Imprimer la page
Connecting The PSW100
The following diagrams illustrate four of the most common types of subwoofer connections. This information will
guide you through the connection process.
All signals that are input into your PSW100 will first pass through the crossover. The subwoofer will reproduce the
portion of the signal below the crossover frequency setting. The full, unprocessed speaker level signal will be pass to
the speaker level outputs. If you have a choice of connection options, remember that it may be less expensive and
more convenient to run long distances with speaker wire than with line level interconnects.
Speaker Level Input
These inputs are designed to accept an amplified signal from the speaker outputs of a receiver, power amplifier or
other device not equipped with line level outputs.
Speaker Level Output
The full, original amplified signal from your source component's speaker outputs is made available here for
connection to existing left and right loudspeakers.
Line Level Input
These RCA jacks are designed to accept a line level signal from a receiver, pre-amp, surround sound decoder or
similar device. When using a single line level input from a device such as a surround receiver or surround decoder, it
is not necessary to use a "Y" connector because the right and left line level inputs are summed. Therefore, in the
case of a single "subwoofer" line level output from a surround sound device simply connect to either of the line level
inputs of the PSW100. If the line level subwoofer output is controlled through an internal crossover in the surround
sound device, you should make sure that the crossover frequency of the PSW100 is set to a frequency well above
the crossover frequency set by the surround sound device.
Line Level Connections
In this example, the pre-amp outputs of a stereo receiver,
pre-amp or other device are connected to the PSW100's
line level inputs.
Note: You would never connect both the line level inputs
and speaker level input at the same time.