Contacta STS-K035-B-RH Manuel d'installation et d'utilisation - Page 13

Parcourez en ligne ou téléchargez le pdf Manuel d'installation et d'utilisation pour {nom_de_la_catégorie} Contacta STS-K035-B-RH. Contacta STS-K035-B-RH 16 pages. Window intercom system curved microphone kit

Imprimer la page

Engineers Mode allows you to adjust the Volume In and Out levels, Ducking

levels and Hearing Loop levels to better suit your environment and achieve

the best possible performance.

Before entering Engineer's Mode, cycle the power. To do this either:

•

Switch the power off at the mains socket and back on again

•

Remove the power connector and re-insert it

To enter Engineer's Mode, simultaneously press and release the following

buttons within 20 seconds of cycling the power:

•

Settings button

•

Volume In increase button

•

Volume Out increase button

Number 1 LED on the Volume In will flash green to indicate that you are in

Engineer's Mode.

The on/off and settings buttons in Engineer's Mode operate as follows:

Move to the next setup area

The amplifier will automatically exit Engineer's Mode if no buttons are

pressed for 2 minutes.

There are 3 editable setup areas in Engineer's Mode. You will always enter

setup area 1 first. The green Volume In LED bar will flash to indicate which

setup area you are in.

Setup Area 1 allows you to adjust the Volume In and Volume Out levels to

further optimise the system for the environment in which it is installed.

Increase maximum

staff volume level

Decrease maximum

staff volume level

Engineer's Mode

Maximum Volume Adjustment (LED 1 flashes)

Save and exit Engineer's Mode

Setup Area 1:

Increase maximum

customer volume level

Decrease maximum

customer volume level