DURASTAR DRPTACWS Instructions de montage - Page 2

Parcourez en ligne ou téléchargez le pdf Instructions de montage pour {nom_de_la_catégorie} DURASTAR DRPTACWS. DURASTAR DRPTACWS 2 pages. Foldable ptac wall sleeve

Imprimer la page

Back-Side Drain Installation (CONTINUED)

3. Install the tube and drain outlet plate to the outlet

located at the back of the sleeve with two screws

and install the cover plate to the other outlet using

two screws as shown below.

NOTE: The drainage tube may be placed on either

side of the sleeve. Before tightening the screws,

make sure the tube's position will allow the sleeve to

ﬁt through the wall.

Bottom-Side Drain Installation

1. Attach a foam gasket to the drain outlet plate and

cover plates as shown below.

Cover Plate

Drain Outlet Plate

2. Insert the straight tube into the drain outlet plate as

shown below.

Cover Plate

Bottom-Side Drain Installation (CONTINUED)

3. Drill two 1/8" holes in a suitable position of the

bottom of the wall sleeve to line up with the holes of

the drain outlet plate. Then drill one 3/8" ~1/2" hole

in the middle of the two holes as shown below.

Holes of the

cover plate

4. Attach the tube and drain outlet plate to the bottom

of the wall sleeve using two screws. Gently tighten the

screws at the same time to avoid damaging the tube.

5. Install the two cover plates over the outlets on the

back of the sleeve using four screws. Fasten tightly

to avoid leaks.

3/8 ~1/2

2- 1/8

V1.0 0822