DAPAudio Cesium Cesium 300 Manuel - Page 7

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} DAPAudio Cesium Cesium 300. DAPAudio Cesium Cesium 300 11 pages.

In stereo mode, this potentiometer allows the adjustment of the channel 2 input level. (Right channel)

In bridge mode, this potentiometer is disabled.

7. "PROTECTION" Indicator

When this indicator lights, the power amplifier is in protection mode. Switch off the device and find out

what the problem is. The power amplifier is protected against overheat, overload, short circuit, DC,

soft-start.

8. "SIGNAL" Indicator

The illumination of the LED only indicates a safe operation.

9. "POWER" Indicator

This indicator lights when the power amplifier is switched on.

CESIUM SERIES DESCRIPTION REAR PANEL:

10. AC Socket

Plug this cord into the power supply socket. (Before using the power amplifier, check if the power supply

is 240V).

11. Channel 2 XLR Input

This XLR input is a balanced input. Connect this input to the left output of your mixer.

12. Channel 1 XLR Input

This XLR input is a balanced input. Connect this input to the right output of your mixer.

13. Operation Mode Selector

This switch is used to choose the operating mode of the power amplifier:

Stereo Mode: 2 inputs (channel 1 and 2) and 2 outputs are used.

Parallel Mode: 1 input (channel 1) and 2 outputs are used.

14. High Pass Filter Selector

This switch is used to cut low frequency under 30Hz (infrasound).

15. Input Sensitivity Selector

This selector allows you, to choose the input sensitivity: 0.77V, 1.0V or 1.4V.

16. Ground Selector

If you experience hum or noise in your speaker, put the selector in "ON" position.

17. Channel 2 Turn lock Output

Connect this turn lock output to a speaker. The branching is +1, -1 (except in bridge mode where the

branching is +1, +2).

18. Channel 1 Turn Lock Output

Connect this turn lock output to another speaker. The branching is +1, -1.

19. Air Entrance

This part is the air entrance. Don't obstruct it.

20. Fuse

The fuse is used to protect your amplifier from different kinds of AC problems. If the power amplifier is

"on" and nothing lights, please check the fuse compartment. If fuse is broken, please

fuse of the same type and specification.

12 13 14 15 16

be sure to use a