DAPAudio D6112 Manuel - Page 10

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} DAPAudio D6112. DAPAudio D6112 18 pages.

to have this function disabled forever, please contact a qualified SERVICE CENTER.

26) IEC Connector

27) AC fuse

28) Ground (GND) screw

Adjusting sensitivity for the "voice priority" function

To change the level of the signal determining activation of the "Voice Priority" function:

1) Unscrew the 6 screws on each side of the amplifier and take off the cover.

2) Inside the amplifier locate trimmer "VR 103" on the input PCB.

3) Using a small screwdriver and adjust the trimmer "VR 103". By turning the control clockwise the

sensitivity increases.

4) Put the cover back onto the amplifier.

Fig. 3

Installation

PA180 Installation

Remove all packing materials. Check that all foam and plastic padding has been removed. If you want to

use the amplifier in a 19" Rack, you must first install the 19" flaps. Then screw the amplifier/CD player in a

19" Rack. Connect all cables.

Always disconnect from electric mains power supply before cleaning or servicing.

Damages caused by non-observance are not subject to warranty.

Before plugging the unit in, always make sure that the power supply matches the product specification

voltage. Do not attempt to operate a 120V specification product on 240V power, or vice versa.

Do not supply power before

all components of the system are

set up and connected properly.