DAPAudio Vision 2400 Manuel - Page 9

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} DAPAudio Vision 2400. DAPAudio Vision 2400 18 pages. Vision mkii series high power stereo amplifier
Également pour DAPAudio Vision 2400 : Manuel du produit (16 pages)

Imprimer la page

15. Operation Mode Selector

This switch is used to select the operating mode of the power amplifier:

Stereo Mode: 2 inputs (channel 1 and 2) and 2 outputs are used.

Parallel Mode: 1 input (channel 1) and 2 outputs are used.

Bridge Mode: 1 input (channel 1) and 1 output is used.

16. Channel 1 Speakon Output

Connect this Speakon output to a speaker. Use connections +1and -1 (except in bridge mode where

the connections are +1and +2).

17. Air Entrance

This part is the air entrance. Don't obstruct it.

18. Channel 2 XLR Input

This XLR input is a balanced input. Connect this input to the right output of your mixer.

19. Channel 2 Link Socket

This balanced socket is used to link another amplifier.

20. High Pass Filter Selector (Vision 1600 only)

This switch is used to cut low frequency under 30Hz. Put the switch in the "ON" position when you want

to use the power amplifier with one (or several) subwoofer speakers.

21. Ground Selector

If you experience hum or noise in your speaker, put the selector in "ON" position.

22. Channel 2 Speakon Output

Connect this Speakon output to a speaker. Use connections +1 and -1.

23. IEC Power Connector with integrated fuse holder (Vision 1600 only)

24. High Pass Filter Selector (Vision 2400 and Vision 3500 only)

This switch is used to cut low frequency under 30Hz. Put the switch in the "ON" position when you want

to use the power amplifier with one (or several) subwoofer speakers.

25. Limiter ON/Off (Vision 2400 and Vision 3500 only)

26. 150 Low Pass filter (Vision 2400 and Vision 3500 only)

For use in crossover applications.

27. Binding- post channel 1 (Vision 2400 and Vision 3500 only)

Can be used instead of the Speakon connectors.

28. Binding- post channel 2 (Vision 2400 and Vision 3500 only)

Can be used instead of the Speakon connectors.

29. AC Cord (Vision 2400 and 3500 only)

Plug this cord into the power supply socket. (Before using the power amplifier, check if the power

supply is 240V).

30. Fuse (Vision 2400 and 3500 only)

The fuse is used to protect your amplifier from different kinds of AC problems. If the power amplifier is

"on" and nothing lights, please check the fuse compartment. If a fuse is broken, please

a fuse of the same type and specification

be sure to use