DAPAudio GIG-12 Manuel de l'utilisateur - Page 8

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} DAPAudio GIG-12. DAPAudio GIG-12 20 pages.

Imprimer la page
21. Effect
Seleclor
Use
ihis
diol
for
selecting on effect preset.
22.
SI/SUB
return
This
control ollows you to odjust the level of the
Digitol Effect unit
to the Moin
(ST)
mix.
23.
EFX
Aux
The
(siereo)
output of the digitol effect section
is
summed
ond
routed lo the oux
bus. You
con
odjust
the level to the oux
bus
with
this
control.
24.
EFX
PFt
Allows
you
to route output of the digitol effect section to the
PFL
bus.
25.
EFX
on/oii
This
switch ollows you
to octivote the built
in
digitol effect
processor.
26.
Time
This
control
ollows
you
to odjust the deloy
or
reverb
time of the selected effect
preset.
27.
Signol
LED
lndicotes on oudio signol
is
present
of the input of the effect section.
28.
Clip
tED
lndicotes the input signolis to high ond cousing the input of the digitol effect section to clip.
lf this
LED
blinks
or light continuously, lower
the setting of the
EFX
Send
(41)
control.
29.
Phontom Power
IED
This
LED
indicotes when the phontom power
is
switched on for the microphone inputs. After swiiching on
the
mixer,
the red
LED
should
not light up.
So
both bolonced ond unbolonced
microphones
con be
connected. Unbolonced microphones moy be domoged
if
the Phontom power
is
octivoted however
unbolonced
microphones ore rorely
to be found
these doys.
Moke
sure
lo
close
lhe fqder
of
lhe corresponding inpul chonnel
or
ot leosl the
MASTER
conlrols before
connecling ony oudio
signol sources.
This
will sove yourself, your
oudience, ond your equipment from
unnecessory
slress
resulling from
plug-in
noise.
30.
Phontom Power Switch
Press
this
button to turn the phontom power
+4BV
on. Do not connect ony unbolonced microphones with
the phontom power switched on.
The
red Phonlom
LED
(31)
will
light if
the phontom power
is
octivoted.
31.
Aux
Relurn
The
signol of
the
(stereo)
Aux
I
relurn inpuls (54)
is
summed
to o mono oux signol ond
is
routed to the oux
bus. You
con
odjust
the level of the Aux
I
return input (54)
to the (mono)
oux
bus
with
this
control.
Worning:
lf
you
use
the
oux
I
inpul in combinotion with the
oux send
output
os
on effecl send relurn, moke
sure lhis
conlrol
is
sel
lo
its
minimum position (fully counterclockwise)
olherwise
you will creote
o
feedbock loop.
lf
you're
using
lhis qs
qn effecl relurn you hove to odjust the relurn level
with
the
ST/SUB
(37)
control.
t2