DAPAudio GIG-6 Manuel de l'utilisateur - Page 12
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} DAPAudio GIG-6. DAPAudio GIG-6 19 pages.
Imprimer la page
6 / 7 / 8. Equalizer SECTION (High / Mid / Low)
The mixer's Equalizer section allows shaping of the incoming audio signal. All mono input channels are
fitted with 3-band EQ. The upper (High (6)) and lower (Low (8)) shelving controls have their frequencies
fixed at 12 KHz and 80 Hz respectively. The Mid range control (Mid (7)) has a peaking response frequency
at 2.5 KHz. All 3 bands have up to 15 dB cut and boost, with a centre detent. Turning the Equalizer to the
right amplifies the frequency range, turning to the left attenuates the signal. Minor changes to the
Equalizer control usually produce the best results. Try to avoid excessive enhancement of the MID band.
9. AUX
The aux control allows you to adjust the aux level in the main mix.
10. Pan (Mono Channels)
By using the panorama control you can change the input signal's position within the stereo image. When
the panorama control is set to center position, the audio signal is equal for both the left and right output.
Bal (stereo channels)
By using the balance control you can adjust the balance between the left and the right channel. If you
use a mono source (input left mono) the control works as a panorama control and lets you change the
input signal's position within the stereo image.
11. Peak LED
The peak indicator shows peak levels in a channel's incoming signal level. If the red peak LED frequently
blinks or constantly lights, the corresponding channel is likely to enter clipping and you have to reduce
the input's amplification using the gain control. The peak LED lights at a level of 8 dB below clipping.
Make sure that the Peak LED lights only briefly during dynamic peaks.
12. Level
The level control allows you to control the volume of a single channel.
13. Aux return
This control allows you to control the aux level in the
main mix.
14. Phantom Power Switch
Press this button to turn the phantom power +48V on.
Do not connect any unbalanced microphones with
the phantom power switched on. The red Phantom
LED (26) will light if the phantom power is activated.
15. Tape/rec to control
Use this button to assign the tape in (33) input to the
Phones/Control bus. The level of the tape in (33)
input is fixed.
16. Tape/rec to master
Use this button to assign the tape in (33) input to the
master bus. The level of the tape in (33) input is fixed.
17. Send
This control allows you to adjust the input for the built
in DSP echo effect. Make sure not to overload the
DSP input.
18. Feedback
This control allows you to control the effect feedback
level of the built in echo effect. The number of times
the delay sound is repeated, increases if the knob is
turned clockwise.
10