DAPAudio IMIX-5.3 Manuel du propriétaire - Page 11

Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} DAPAudio IMIX-5.3. DAPAudio IMIX-5.3 16 pages.

Imprimer la page
DAPAudio IMIX-5.3 Manuel du propriétaire
28. Headphone out connector
You can connect a pair of headphones with an impedance of 32 - 600 Ohm to the headphones
connector. It is a 6,3mm/ 1/4" TRS socket, wired as Tip=left, Ring=right and sleeve = ground.
Caution: Depending on the type of headphones connected to the Headphones jack, the IMIX-5.3 is
capable of producing high output levels via the phones output. Therefore, make sure to turn the
control all the way to the left (minimum setting) before connecting the headphones. Be aware of the
fact that listening to loud sound pressure levels over a longer period of time leads to hearing damage!
29. Aux level control
This control allows you adjust the level of the aux (17,20) inputs in the master mix.
Fig. 3
30.
Power adapter connector
This is the remote AC power supply input socket for the IMIX-5.3 It is a special three core socket. Please
use the supplied DAP audio adapter only.
31. Zone C XLR balanced out connectors
Use these outputs to connect an amplifier with balanced inputs.
32. Zone B XLR balanced out connectors
Use these outputs to connect an amplifier with balanced inputs.
33. Zone A XLR balanced out connectors
Use these outputs to connect an amplifier with balanced inputs.
34. Zone C RCA unbalanced out connectors
Use these outputs to connect an amplifier with unbalanced inputs.
35. Zone A RCA unbalanced out connectors
Use these outputs to connect an amplifier with unbalanced inputs.
36. Zone B RCA unbalanced out connectors
Use these outputs to connect an amplifier with unbalanced inputs.
37. Channel 4 RCA line input connectors
Use to connect a line level device. You can select one of the two line inputs with the corresponding input
selection (11) switch on the frontpanel.
38. Channel 3 RCA line input connectors
Use to connect a line level device. You can select one of two the Line inputs with the corresponding
input selection (11) switch on the frontpanel. Use the phono input to connect a turntable
39. Channel 2 RCA line/phono input connectors
Use the line input to connect a line level device. Use the phono input to connect a turntable.
40. Channel 1 RCA line/phono input connectors
Use the line input to connect a line level device. Use the phono input to connect a turntable.
41. GND screw
Use to connect the ground wire of your turntable.
10