DAPAudio D1356 Manuel - Page 7

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} DAPAudio D1356. DAPAudio D1356 12 pages.

Imprimer la page
DM-35

Set Up and Operation

Follow the directions below, as they pertain to your preferred operation mode. Before plugging the unit
in, always make sure that the power supply matches the product specification voltage.
01) Set all volume and gain controls on your mixer, mic preamp or recording device to the minimum
before connecting the microphone. Make sure that the phantom power is off!
02) Once the DM-35 is plugged in, move the channel fader gradually to the 0dB position. Adjust the
input gain, using your channel peak LED or the VU-meter.
03) Make sure the microphone is aimed towards the speaker with the front side (silver).
04) Position the microphone exactly in the middle between the edge of the dust cap and the edge of
the speaker as shown on Fig. 02, page 6.
05) Once positioned, use your ear to find the optimum position. Moving the microphone in the direction
of the dust cap will increase the brilliance of the signal. Moving the microphone towards the edge of
the speaker will decrease the brilliance, and the sound will become warmer.

Setup example

Make sure the front of the microphone (silver side) is facing the speaker.
Position the microphone exactly in the middle between the edge of the dust cap and the edge of
the speaker as shown on Fig. 02, page 6. Once positioned use your ear to find the optimum position.
Moving the microphone in the direction of the dust cap will increase the brilliance of the signal.
Moving the microphone towards the edge of the speaker will decrease the brilliance, and the sound
will become warmer.
Ordercode: D1356
6
Fig. 02