DAPAudio D2181 Manuel du produit - Page 8

Parcourez en ligne ou téléchargez le pdf Manuel du produit pour {nom_de_la_catégorie} DAPAudio D2181. DAPAudio D2181 16 pages.

Imprimer la page

Backside

34) Fader Start B
35) Fader Start A
36) Channel 3 CD/ Phono Selector
37) Channel 2 CD/ Phono Selector
38) Channel 1 CD/ Phono Selector
39) GND
40)
AC Inlet with integrated fuse holder
41) Master RCA Balanced Out
42) Master RCA Unbalanced Out
43) Booth RCA Out

Installation

Remove all packing materials from the DS-CM-6. Check that all foam and plastic padding is removed.
Connect all cables.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.

Functions

.
work.
4. MIC
Electronically balanced XLR-type input for connecting low impedance microphone. The input has
exremely low noise hum. When connecting a microphone make sure that the pin assignment is
correct. Always make sure to read the manual of the microphone you want to connect. The XLR- input
1. Talkover Swicth
This switch has three modes:
A. -12dB: With the switch in this position, the input level of channel 1-4 is
attenuated by 12dB. Making it easy for you to make an an
anouncement using the DJ- microphone.
B. On: With the switch in this position, the talkover function is deactivated
and channel 1-4 are not attenuated.
C. Auto Talkover: In this position the channels 1-4 are automatically
attenuated by 12dB while speaking in the DJ-microphone.
2. Talkover Sensitivity Control
Use this control to set the input sensitivity for the auto talkover function. In
zero position the sensitivity is minimal and the talkover function will not
3 / 5. EQ HIGH / LOW
The mixer's Equalizer section allows shaping of the incoming audio signal.
The Mic channel is fitted with a 2-band EQ. The upper (3) and lower (5)
shelving controls have their frequencies fixed at 10 Khz and 50 Hz
respectively.
44) Rec Out
45) Channel 4 L2 RCA Input
46) Channel 4 L1 RCA Input
47) Channel 3 L2 RCA Input
48) Channel 3 L1 RCA Input
49) Channel 2 L2 RCA Input
50) Channel 2 L1 RCA Input
51) Channel 1 L2 RCA Input
52) Channel 1 L1 RCA Input
53) Mic 2 Jack Unbalanced Input
6
Fig. 2