DuraVent DirectVent Pro Manuel d'instructions d'installation - Page 5

Parcourez en ligne ou téléchargez le pdf Manuel d'instructions d'installation pour {nom_de_la_catégorie} DuraVent DirectVent Pro. DuraVent DirectVent Pro 8 pages. Chimney liner system for use with direct vent gas appliances
Également pour DuraVent DirectVent Pro : Manuel d'instructions d'installation (12 pages)

Imprimer la page

short, a flex coupler will be needed to attach

an additional length of Flex Liner to make up

the difference. If the flex length is too long,

the liner could sag below the appliance outlet

which could result in a potential fire hazard.

Note: For installation in a zero clearance

chimney, you must have at least a 7" I.D.

in order to run the two lines of Flex Liner

needed.

INSTALLATION IN MASONRY OR

ZERO CLEARANCE CHIMNEY

Step 1. Measure and record dimensions to

determine total Flex Liner length requirements

(see instructions below for details).

Step 2. Insert a rope through the end of the

Flex Puller and tie a knot at the end of the

rope. Attach the Flex Puller to the Flex Liner

using four sheet metal screws as shown.

(Figure 2) Carefully feed the liner down the

chimney (masonry or zero clearance) and out

through the damper. One person should feed

the liner through the chimney, and another

person should pull the liner from the bottom,

using the rope to guide the liner through to the

chimney bottom. Note: If additional lengths

of Flex Liner are needed span the chimney

height, use a Flex Coupling to connect the

pieces of Flex Liner together. Connect the

Flex to the Coupling by using four sheet metal

screws for each side. (Figure 3).

Step 3. After carefully feeding the Flex Liner

down the chimney to the bottom, form an

angle to line up the Flex Liner with the vent

opening on the appliance. Important: Do not

let the Flex Liner sag below the level at which

it will connect to the appliance or connector.

This could allow hot gas to become trapped

and potentially become a fire hazard. The Flex

Liner path should always be sloped up toward

the Termination Cap.

Step 4. Remove the Flex Puller from the Flex

HIGH WIND

TERMINATION CAP

CO-AXIAL TO CO-LINEAR

APPLIANCE CONNECTOR

Figure 1

ROPE (NOT PROVIDED)

Figure 2

STANDARD

TERMINATION CAP

CO-LINEAR

TO CO-AXIAL

ADAPTER

BASEPLATE

FLEX LINER

CO-LINEAR FLEX

CONNECTORS

STOVE OR INSERT WITH EITHER

CO-AXIAL OR CO-LINEAR OUTLET

FLEX LINER

FLEX PULLER