DuraVent PelletVent Manuel d'instructions d'installation - Page 7

Parcourez en ligne ou téléchargez le pdf Manuel d'instructions d'installation pour {nom_de_la_catégorie} DuraVent PelletVent. DuraVent PelletVent 16 pages. Multi-fuel venting system

Imprimer la page

desired (Figure 6):

A. Place the appliance according to

manufacturer's instructions.

B. Connect the Pipe Adapter to back of stove

and attach sufficient pipe to penetrate Wall

Thimble and extend at least 6" beyond the

exterior wall. You may install the optional

House Shield as shown in Figure 6. The

House Shield is used to protect the exterior

wall from vent discharge. Attach a Square or

Round Horizontal Cap. The Round Horizontal

Cap can be swiveled to be directed away

from nearby objects (fence, plants, etc.),

but must still be pointing in a generally

downward direction. Important: Horizontal

Caps must be pointed in a generally

downward direction to insure rain and snow

do not enter the cap, and cause potential

WARNINg

WARNINg: Do not install any insulation

or other material inside the Wall

Thimble. Doing so can create a fire

hazard. The Wall Thimble requires the

created air clearance from the pipe

in order to make a safe installation.

However, building insulation may be

installed around the outside of the Wall

Thimble

damage to the appliance. Either vent Cap

should be at least 6" from the wall.

C. Follow the below listed NFPA 211 rule for

distance of exit terminal from windows and

openings:

NFPA 211 (2003 ed.) Section 10.4 Termination:

10.4.5 (1) The exit terminal of a mechanical

draft system other than a direct vent

appliance (sealed combustion system

appliance) shall be located in accordance

with the following:

(a) Not less than 3 ft (.91m) above any forced

air inlet located within 10 ft. (3m).

(b) Not less than 4 ft. (1.2m) below, 4 ft. (1.2m)

APPLY HIGH

TEMPERATURE

SEALANT COMPLETELY

AROUND TOP EDGE OF

STORM COLLAR

SHINGLES OVERLAP ON

TOP EDGE OF FLASHING

Figure 2

PIPE

ADAPTER

Figure 3

12 INCHES

MINIMUM

12" MIN

ATTIC

INSULATION

SHIELD

CEILING

SUPPORT/

FIRESTOP

SPACER

TEE WITH

CLEAN-OUT

ADAPTER