Contemporary Research ICC-ZS2 Manuel du produit - Page 5
Parcourez en ligne ou téléchargez le pdf Manuel du produit pour {nom_de_la_catégorie} Contemporary Research ICC-ZS2. Contemporary Research ICC-ZS2 17 pages. Lg/zenith superport controllers
Également pour Contemporary Research ICC-ZS2 : Spécifications (2 pages), Vue du produit (1 pages)
Imprimer la page
Installation
SmartPort Installation
1. Turn off TV.
2. Zenith CRT TVs have 2 card spaces. If there is a blank plate, don't use that space for the iC-Net card.
ATSC CRT TVs, place card in the Antenna/Cable slot – placing in the Digital/Antenna slot can damage the
TV. Replace the existing card that has the F connector with the SuperPort card. LCD units have one slot.
3.
Remove existing card, removing internal Ground and RF wires if attached.
Pull out card partially, then disconnect wires before completely removing.
4. Connect internal Ground and RF wires to ZS2 card.
5. Insert ZS2 card into SuperPort.
6. Turn on TV.
7. The NET LED should light and stay on, indicating power, but not iC-Net communication.
8. COM LED turns on when data link with TV is established, blinks when data sent from IR remote, front-
panel buttons, or iC-Net commands.
RF Coax and iCC-Net Operation (ICC1-, ICC2-ZS2)
1. Connect the CATV RF Coax cable into the ANT/CABLE jack.
2. If the iCC-Net signal is operating, the Net LED will blink once per second
Zenith ScanCard DIP Switch
We have included a 4-position DIP switch that enables ScanCard compatibility with older Zenith TVs.
1. All four DIP switches are set to the OFF position from the factory – this is the normal setting for new TVs
and older models without ScanCards.
2. If you are installing the ICC-ZS2 in an existing TV that has a ScanCard, turn all four switches ON.
3. If the switches are set ON in a new TV, you will likely hear electronic noise in the audio.
Contemporary Research
5
ICC-ZS2 Zenith SuperPort Card
For