Apogee X-HD Manuel de l'utilisateur - Page 13

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Apogee X-HD. Apogee X-HD 15 pages. X-series expansion card
Également pour Apogee X-HD : Fiche technique (1 pages)

Imprimer la page
X-HD card – User's Guide
APPEARS AS...
in Hardware Setup
INTERFACE SET
AD-16X, DA-16X & ROSETTA 800
From Computer
P
E
P
E
From Computer
P
E
P
E
From Computer
P
E
P
E
P
E
From Computer
P
E
P
E
P
E
DIGI, AD-16X & DA-16X
From Computer
P
E
P
E
From Computer
P
E
P
E
APOGEE ELECTRONICS
CHANNELS IN USE
A1-16
B1-16
AD-16X: Analog In
INPUT
AD-16X: Digital Out
ROSETTA 800 #1
OUTPUT
A1-16
B1-16
DA-16X: Digital In
INPUT
DA-16X: Analog Out
ROSETTA 800 #1
OUTPUT
A1-16
B1-16
AD-16X: Analog In
INPUT
AD-16X: Digital Out
ROSETTA 800 #1
ROSETTA 800 #2
OUTPUT
A1-16
B1-16
DA-16X: Digital In
INPUT
DA-16X: Analog Out
ROSETTA 800 #1
ROSETTA 800 #2
OUTPUT
A1-16
B1-16
AD-16X: Analog In
INPUT
DIGI 192 #1
AD-16X: Digital Out
OUTPUT
A1-16
B1-16
DA-16X: Digital In
INPUT
DA-16X: Analog Out
DIGI 192 #1
OUTPUT
16
X-HD card – User's Guide

Installing the X-HD card

Your X-HD card should include the following:

2
1 X-HD circuit board
1 X-HD Coverplate
2 aluminium standoffs
1 plastic standoff
1 Remove the top cover of the host interface.
2 Remove the Option Card coverplate, and set aside the screws for
later use.
3 Remove the two interface circuit board screws indicated at left, and
set them aside for later use.
4
4 Install the two aluminium standoffs in the threaded holes vacated
3
by the screws.
5 On the X-HD card, install the plastic standoff in the hole adjacent to
the multi-pin motherboard connector.
6 Insert the Port connector end of the X-HD card through the host
unit back panel, and carefully place the multi-pin motherboard con-
nector in the mating connector found on the host interface mother-
board.
7 After verifying the alignment of the multi-pin and the mating con-
nectors, firmly press down on the X-HD card, over the connector,
until the pins are completely seated in the mating connector.
8 Re-install the circuit board screws from Step 3 in the locations
indicated below.
6
5
9 Install the X-HD Coverplate, and secure it to the host inteface using
two screws from Step 2.
10 Replace the top cover of the host interface.
8
APOGEE ELECTRONICS
9
9
17