Apogee 05058 Manuel - Page 6

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} Apogee 05058. Apogee 05058 12 pages.

Imprimer la page

30. Cut the provided string into four equal lengths by

folding in half twice (as shown). Tie the shroud lines to

the ring holes. Place a small amount of glue on each of

the knots to keep them from coming untied and set the

parachute aside to dry.

31. Once dry, place the parachute top down and lift the

shroud lines one at a time near the center and stack them

together over a finger, making sure that they are well

organized. Pull the parachute at the center to tighten the

lines and even them out. Thread the four looped ends

through the bulkhead loop on the forward section. Pass

the center of the parachute back through the shroud line

ends and then pull the parachute to tighten the knot.

Finishing

32. Once completely dry, fill and sand any particularly

rough sections of the surface. Spray a coat of primer

over the entire rocket. When painting the Quick Draw,

take care to avoid getting paint in the rear of the rocket

to avoid fit problems with removable mounts. Sand the

primer entirely before applying color coats.

33. Allow the final coat of paint to harden for at least a full

day (24 hours) before applying the vinyl decals. To allow

easy repositioning, the decals can be dipped in soapy

water (after removing the paper backing) prior to placing

on the rocket. While positioning, keep the decal wet.

Once it is in the correct location, press it down firmly and

squeegee out any water underneath. When the decal

dries, it will be permanently affixed to the rocket.

34. Congratulations, your Quick Draw is now complete.

Once the removable mounts are built, it'll be ready to fly!

Building the Removable Mounts

1x29mm Removable Mount

1-1. (Optional) Harden 1/4" (6 mm) of the end of the motor

mount tube by saturating the inside with thin CyA glue.

This makes it less prone to damage. This will be the aft

end of the tube.

Page 6

Instructions P/N 31250

Step 30

Shroud lines

through loop

Step 31

Step 32

Step 33

Step 34

Step 1-1

Pass parachute

back through the

shroud lines

Pull tight