Apollo REACH WIRELESS RW1000-600APO Manuel de démarrage rapide

Parcourez en ligne ou téléchargez le pdf Manuel de démarrage rapide pour {nom_de_la_catégorie} Apollo REACH WIRELESS RW1000-600APO. Apollo REACH WIRELESS RW1000-600APO 2 pages. Reach optical smoke detector

Imprimer la page

RW1000-600APO

REACH Optical Smoke Detector

IMPORTANT TO CONSIDER

When mounting a wireless device, a comprehensive radio survey

should have been carried out to establish the location that provides

the best coverage and optimum reach. Taking into consideration the building

structure and materials, the survey identiﬁes the wireless infrastructure

required and product locations for optimum performance, identifying

any factor that could prevent radio integrity.

Avoid ﬁxing or mounting the unit close to the following:

• Equipment that utilises large electrical currents

• Large metal objects or structures

• Fluorescent lighting ﬁttings

• Metal ceiling structures

• IT cabling.

Keep 2 meters minimum spacing between other wireless equipment

in the area to avoid signal interference.

EN54 approved environmental temperature range is -10°C to +55°C

UNBOXING

• When unboxing the detector you will ﬁnd the unit and its mounting base.

• This comes with pre-formed mounting holes to mount the detector base

and a securing screw on the base to ensure there is no unwanted removal.

For more information, please refer to the user manual. Available on apollo-ﬁre.co.uk

Apollo Fire Detectors Ltd. 36 Brookside Road, Havant, Hampshire, United Kingdom, PO9 1JR

T: +44 (0)23 9244 2706 - E: techsales@apollo-ﬁre.com - W: www.apollo-ﬁre.co.uk

REACH Optical Smoke Detector

QUICK START GUIDE

THE BOX

INSIDE THE BOX

Product Part Number

• 1 x Optical Detector

Product Description

with mounting base

• 2 x CR123A batteries

• 1 x Quick start guide

Scan QR code

for full user manual

RW1000-600APO

MOUNTING STEPS

Proceed as follows to complete the device installation.

• Remove the detector's dust cover, intended to protect

the unit during shipping.

• Remove the detector from the base twisting

anticlockwise.

REMOVABLE

TAG

• A plastic pop out tag is removable from the base

to enable you to label the address of the detector,

prior to ﬁxing to the ceiling: pop out the device label tag

from the base and insert it into the side.

• Screw the base to the ceiling using all ﬁxing holes

and appropriate-sized screws.

Ensure the programming switch in the base of the detector

is in position ON.

UNLOCK

• Locate the mounting holes and mark them using a pencil

on the desired surface you are drilling.

• Using a suitable-sized drill bit (6 mm) drill the marked

screw points on your chosen surface.

• Ensure you use the correct ﬁxings for the type of surface

you are mounting to.

Remove the battery compartment cover on the base

on the detector.

SWITCH

Remove the batteries' insulating tab ensuring

the batteries are kept in their lodgement.

RW_QSG_DETECTOR_OPTICAL_REV_A.1

MOUNTING

HOLES

REMOVE

INSULATING

TAG