Apollo Smoke Detector XP95 Manuel d'installation - Page 12

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Apollo Smoke Detector XP95. Apollo Smoke Detector XP95 18 pages. Input/output unit
Également pour Apollo Smoke Detector XP95 : Manuel d'installation et d'entretien (4 pages), Manuel d'installation (2 pages), Manuels d'installation (2 pages), Manuel d'installation (2 pages), Manuel de démarrage rapide (2 pages), Manuel de démarrage rapide (5 pages), Manuel d'installation (2 pages)

Receiver

LED

FLASH

www.acornfiresecurity.com

7. Move the transmitter left, right, up, down until the LED on the receiver

ﬂ ashes fast. Hold the transmitter in this position.

fast ﬂ ash

slow ﬂ ash

8. Reduce the signal strength by turning the potentiometer slowly clock-

wise until the receiver stops ﬂ ashing.

9. Move the transmitter from right to left, in order to see if the receiver

LED can be made to ﬂ ash fast again. If it can, repeat step 8.

Repeat this procedure but this time move the transmitter up and

down.

10.The beam detector is correctly aligned if there is no ﬂ ash after carrying

out the movements described.

To conﬁ rm the correct alignment of the detector move the transmitter

slowly up, down, left and right. Each movement should cause the LED

in the receiver to ﬂ ash slowly. Leave in centre position with no LED

ﬂ ashing.

11. Tighten the securing bolts and screws of the transmitter, making sure

it does not move and replace the plug covering the potentiometer.

Failure to replace the plug may result in false alarms due to ingress

of contaminants.

www.acornfiresecurity.com

signal too strong

signal too weak

no ﬂ ash

signal correct