Daspi RANDY Manuel d'instruction - Page 7

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} Daspi RANDY. Daspi RANDY 13 pages. Gear motor for rolling shutter

Imprimer la page

asseMBlY InstruCtIons randY 150

THE GEAR MOTOR FOR SERIES 150 SHUTTERS HAS BEEN

DESIGNED TO BE APPLIED TO AXLES WITH DIFFERENT

DIAMETERS. IT IS THEREFORE SUFFICIENT, WHEN USING AN

AXLE LESS THAN 60 MM, TO INSERT THE RELATIVE ADDITIONAL

SLEEVE FOR REDUCTIONS FROM 42 OR 48 MM (FIG.1-A)

WHILE WITH SPRING BOXES WITH DIAMETERS OF OVER 200 MM

IT IS POSSIBLE TO INSERT EXPANDERS (FIG.1-B)

THE RANDY GEAR MOTOR HAS THE ADVANTAGE THAT IT CAN

BE FIXED WITHOUT REMOVING T HE AXIS.

1 STAGE

USING AN ELECTRIC DRILL WITH A 11 mm BIT, MAKE THE

FOLLOWING HOLES (FIG.2)

A – Drill the axle 38 mm from the right of the centre, calculating

an inclination of some 20° downwards such as to be able to have

the limit switch box at the front (FIG.2a)

B – Make a hole some 350 mm left of the first one (if using the

brake make two holes next to each other).

C- In conclusion drill the last element of the shutter some 38 mm

to the left of hole a.

2nd Stage

Position the body of the motor in the axle after dismantling the

flanges and the completion sector. Insert the screw supplied (TE

100x10) into hole A between the motor body and the axle inserting

and fully locking the completion sector in place. (FIG.3)

3rd Stage

Rest the half flange on the motor body until adhering perfectly

with the pinion, join the other half and tighten the coupling

screws.(FIG.4)

4th Stage

Tighten up the pressure pin of the completion sector

5th STAGE

Remove the limit switch box cover and attach the power supply

cable to the mains passing it through hole B.. (FIG.5)

6th STAGE

Screw up and tighten the last element of the shutter to the motor

flange through hole C using the screw and washer supplied.

7th STAGE

After connecting any accessory commands (key controlled selector

switch, button pad, electronic control unit etc. ) you must adjust

the limit switch. With the shutter closed, position the switch A on

"DIS" and perform a complete opening and closing operation,

after which move the lever to "INS" and check proper operation

and that the dipswitches have been set properly with a second

manoeuvre . (FIG.6) T o adjust the limit switch dipswitches by hand

just raise the locking wing nut turning the toothed wheel (FIG.7).

asseMBlY InstruCtIons randY 250

THE GEAR MOTOR FOR SERIES 250 SHUTTERS HAS BEEN