App-Tronics SmartVision Manuel opérationnel - Page 11

Parcourez en ligne ou téléchargez le pdf Manuel opérationnel pour {nom_de_la_catégorie} App-Tronics SmartVision. App-Tronics SmartVision 12 pages.

STOP!

Please read the proper installation guide for the SmartVision. The system is designed to

record both cameras at all times when car is powered on. The below installation is needed to run the

DVR and internal functions correctly. If not installed as shown the system will not operate at

maximum performance and may damage the internal PCB board.

Installation instructions for your SmartVision: (App-Tronics recommends installation by a professional

service. Go to app-tronics.com and search dealer locator.) Call 1-888-587-4111 for assistance.

Mirror installation:

1. Each SmartVision comes with a universal mounting bracket that fits most cars. If you ordered a

vehicle specific mount the same installation guidelines may not apply. (Refer to vehicles manual or

consult your dealer for more information).

2. Install the mount that came with your SmartVision using the 4 provided screws, be sure to tighten

firmly but do not over tighten.

3. Remove the factory mirror and install the SmartVision on the existing anchor attached to the

windshield. If choosing to use our universal mount with provided anchor you will need a windshield rear

view mirror repair kit. (Not Provided)

4. Next find your power source to be used for installation. Each SmartVision needs both constant and

accessory power as well as ground. Each main wire harness has these wires marked clearly. Guide the

main harness down the A or B pillar to this location. You can gently remove the weather stripping and

tuck into place then use your fingers to push harness inside headliner to the mirrors location.

A. Using a volt meter locate you constant power source, tap the

this source. Be sure that this constant power source does not "go to sleep" after 15 minutes.

B. Use the same process to find an accessory power source (Power only on while car is running

or in accessory keyed position). The

also tie in the red pigtail wire from the rear camera harness to the same accessory power source.

Splice the wires together. This will allow the rear camera to stay on while car is running to record.

C. The Black wire is your ground, locate a strong solid grounding source. Attach the Black

wire to this location.

5. The

Green

wire at the end of main harness needs to be tied into the vehicles reverse relay in the front

of the vehicle, usually located in the cars BCM module., if it cannot be located you can extend the wire

all the way to the reverse bulb in the back of vehicle. This will trigger the rear camera to display when

car is put into reverse.

Rear camera installation: (App-Tronics recommends installation by a professional service. Go to app-

tronics.com and search dealer locator.) Call 1-888-587-4111 for assistance.

Blue

wire will need to be tapped into this source. You must

Red

wire (12 Volt Positive) into