4F Maschinentechnik Limpar SP-94 Manuel d'utilisation - Page 7

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} 4F Maschinentechnik Limpar SP-94. 4F Maschinentechnik Limpar SP-94 14 pages. Slat scraper

Imprimer la page

Also observe the sequence of the washers when fitting the wheels – see the

attached leaflet or the Appendix to this operating manual.

The scraper implement is to be inserted as per the illustration in section 3.2, with

its shaft positioned in the socket of the main unit and fixed by the spring cotter.

Slotted holes for the upper bolts of the socket allow adjustment if the floor blades

do not rest flat on the ground.

batteries

Finally, the

must be made operational.

Before the first use, the charger supplied must be connected to the

machine, and the batteries must be charged until "Battery full" is displayed.

Read through the operating manual for the charger, and become

familiar with how to use it. The charger should always be connected. It

keeps the batteries in good condition, and when these are fully charged, no

power is consumed.

Important: Never use a conventional charger designed for car batteries! If the

charging current is too high, the batteries may explode.

The charger supplied is a so-called "intelligent charger", which because of its

electronics, works completely differently to a charger for starter batteries.

See the brief instructions under point 7

3.5 Operating instructions

3.5.1 Starting the motor

Turn the main electrical switch clockwise, until it engages. The electrical motor

should now be audible.

3.5.2 Stopping the motor

Turn the main electrical switch anticlockwise, until it is horizontal. The electrical

motor should now no longer be audible. Remove the key and take it with you when

you leave the machine. In this way you ensure that the machine cannot be used

without permission.

3.5.3 Drive mechanism

The drive mechanism is actuated by pulling the switching lever on the right hand

steering arm. Since this is a so-called "dead man's circuit" you must hold the lever

in place for as long as you wish to continue moving. Once the lever is released,

the drive mechanism will be switched off.

If you would prefer to press the lever from above, release the holding clip, and

twist the lever round to the desired position.

Important: the switching lever must always be pulled right against the steering

arm. Letting the clutch "slip" can cause damage from overheating to the

flat clutch belt. (See item 4.1 - Changing the flat belt)

It is forbidden to fix the lever in position. The motor must always be running before

the drive mechanism is activated.