DURKOPP ADLER 610-10 Instructions supplémentaires - Page 12
Parcourez en ligne ou téléchargez le pdf Instructions supplémentaires pour {nom_de_la_catégorie} DURKOPP ADLER 610-10. DURKOPP ADLER 610-10 14 pages. Replacing the dc motor at the tape unwinder
Imprimer la page
3
To allow the tape unwinder to work properly with the new motor, you need
to upload the software stored on the USB key to the machine.
The correct software version is identified by the number A04.11.
Uploading the software to the machine
To upload the software to the machine:
1. Switch off the machine.
2. Plug in the USB key into the OP7000 control panel.
3. Switch on the machine.
The software update starts automatically.
4. Wait until the message Please remove USB memory stick
5. Remove the USB key from the control panel.
6. Switch off and on the machine again.
7. Confirm the displayed message with OK.
Checking the Tape Feeder (tape unwinder) parameter
To check the Tape Feeder parameter:
1. Open the menu Service > Machine Configuration > Other
Fig. 11: Software settings
The value entered here must be 1.
2. If the entered value is NOT 1, use the button panel to correct the value
10
Software settings
appears on the display.
Devices and select the subitem Tapefeeder Motor Type.
and confirm with OK.
Software settings
Additional Instructions 610-10 - 00.0 - 04/2019