Duro Dyne DynaTite CL18-WC4 Instructions d'installation

Parcourez en ligne ou téléchargez le pdf Instructions d'installation pour {nom_de_la_catégorie} Duro Dyne DynaTite CL18-WC4. Duro Dyne DynaTite CL18-WC4 2 pages.

®
Looped Cable
Assembly
Step #1: Pass the end of the wire rope
around the anchor point and through
the cable loop.
Step 2: Using the appropriate cable lock
(see the chart on back), pull adjustment
pin back and pass the end of the wire rope
through the Dyna-Tite Cable Lock.
ALWAYS CONFIRM ENGAGEMENT OF CABLE LOCK ON WIRE BEFORE APPLYING LOAD
*When using Dyna-Stud Drop-In
Step 1: Insert a carbide tip
CAUTION
masonry bit into the ham-
mer-drill chuck and tighten
it in place.
Before
the hole to be drilled can
easily be set by using the
starting
depth gauge on the drill
to drill the
or by wrapping the bit with
hole, it is
tape at the required depth.
Make sure that the hole
important
depth will allow the anchor
that eye
to be flush with the surface
and ear
of the concrete.
protection
are used.
End Fixings Installation Instructions
Step 1:
a convenient anchor point with
appropriate fastener.
Step 3: Loop the wire rope around the duc-
twork or through attachment bracket and
back up through the Cable Lock.
Step 2:
Make sure the
hammer drill is in the
hammer mode and start
The depth of
drilling your hole. Continue
drilling until the tape on the
bit or the drill gauge meets
the base material - this
means that the required
depth has been reached.
Eyelets
Attach the wire rope to
Step 3: Before proceeding
with installation, the hole
must be cleaned of all
concrete dust to ensure
proper fastening. Use a
wire brush, a vacuum or
compressed air to clean
out the hole completely.
Swaged
'L'
Dyna-Stud
CABLE
(LISTED)
45° EYELET
(LISTED)
'L'
CABLE
90° EYELET
(LISTED)
(LISTED)
'L'
1-1/2"
CABLE
(LISTED)
BRACKET w/DRIVE PIN
Step 1: Insert and tighten the Dyna-
Stud into a threaded receptacle of the
corresponding size. A locking jam nut
is recommended to prevent the Dyna-
Stud from turning. *If using Drop-In
see instructions below.
(sold separately)
Step 5: Now, take the
Step 4: Next, insert the
setting tool and insert
drop-in anchor with the
open side up. Drop the
it into the anchor.
anchor into the hole. Tap
Strike the setting tool
lightly to get the anchor
with a hammer until
flush
with
the
base
the lip of the anchor
touches the lip of the
material.
setting tool. This will
ensure the anchor is
properly set.
: