4gon RouterBOARD 411U Manuel d'installation rapide

Parcourez en ligne ou téléchargez le pdf Manuel d'installation rapide pour {nom_de_la_catégorie} 4gon RouterBOARD 411U. 4gon RouterBOARD 411U 2 pages.

Imprimer la page

RouterBOARD 411U

Quick Setup Guide and Warranty Information

Assembling the Hardware

First use of the board:

●

Optional: Insert a miniPCI card into the miniPCI slot

●

Optional: Insert a 3G miniPCI-e card (WLAN cards won't work in this slot) into the miniPCI-e slot, and the Phone's SIM

card into the SIM slot.

●

Install the board in a case and connect other peripherals (USB) and cables (Ethernet, Antenna cable).

●

Plug in power cable to turn on the board (If not using PoE power over LAN). Please do not power on the device before

the antenna cables are connected to avoid possible damage to the wireless card.

Powering

The board accepts powering from either the power jack or the LAN1 Ethernet port:

●

direct-input power jack J7 (5.5mm outside and 2mm inside diameter, female, pin positive plug) accepts 9..28V DC

(overvoltage protection starts at 28V).

●

LAN1 Ethernet port J8 accepts 9..28V DC input (at the board; higher voltage needed to compensate for power loss on

long cables; at least 18V suggested) from non-standard (passive) Power over Ethernet injectors (no power over

datalines). The board does not work with IEEE802.3af compliant 48V power injectors.

The maximum output of the power supply available for extension cards is normally 10W (3.0A).

Booting process

First, RouterBOOT is started. It displays some useful information on the onboard RS232C asynchronous serial port. The serial

port is set by default to 115200bit/s, 8 data bits, 1 stop bit, no parity . Note that the device does not fully implement the

hardware (RTS/CTS) flow control, so it is suggested to try to disable hardware flow control in the terminal emulation

program in case the serial console does not work as expected, and if it does not help, make a new cable using the pinout

given in the User's manual. The loader may be configured to boot the system from the onboard NAND, and/or from network.

See the respective section of User's manual on how to configure booting sequence and other BIOS parameters.

http://wiki.mikrotik.com/wiki/First_time_startup

DHCP or BOOTP (configurable in loader) protocols allow the RouterBOARD 411U device to get an initial IP address, and

provide the address of a TFTP server to download an ELF boot image from. It is especially useful for software installation.

See the User's manual for more information and protocol details. Note that you must connect the RouterBOARD you want to

boot and the BOOTP/DHCP and TFTP servers to the same broadcast domain (i.e., there must not be any routers between

them – they must be on the same Ethernet switch).

4Gon www.4Gon.co.uk [email protected] Tel: +44 (0)1245 808295 Fax: +44 (0)1245 808299

rev. A (7-Jul-2009)