Data-Tronix DT-QAM-ENCMOD-8 Manuel de l'utilisateur - Page 5
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Data-Tronix DT-QAM-ENCMOD-8. Data-Tronix DT-QAM-ENCMOD-8 20 pages.
Imprimer la pageUnpacking and Handling
A full DT-QAM-ENCMOD-8 is shipped with all equipment assembled, wired, factory tested, and then
packaged in an appropriate shipping container.
•
DT-QAM-ENCMOD-8 digital modulator (QTY=1)
•
Power Cord and 3-pin plug (QTY=1)
Mechanical Inspection
Inspect the front and rear of the equipment for shipping damage. Make sure the equipment is clean,
and no wire, cable, or connectors are broken, damaged or loose.
Precautions
•
Avoid heat buildup
•
Ensure easy access to rack wiring
•
Facilitate servicing and maintenance
•
Avoid direct heating or air conditioning
•
Make sure rack supports are sufficiently rigid to support racks
•
Beware of dripping water onto equipment form leaky roofs, waveguide roof entries and cold
water pipe condensations
Damage in Shipment
Should any damage be discovered after unpacking the unit, immediately contact
DataTronix at 800-688-9282.
Installation
The DT-QAM-ENCMOD-8 is designed to be installed in a rack shelf or a standard rack. Please fol-
low the instructions below to install the DT-QAM-ENCMOD-8 digital modulator:
1. Connect the power plug to the jack
2. Connect the video source to the DT-QAM-ENCMOD-8 modulator
3. Connect the DT-QAM-ENCMOD-8 to your laptop or computer
4. Power up the modulator
DT-QAM-ENCMOD-8 Manual
5 5